Honda Element. Manual — part 92
Fig. 13: Precaution For Installing Harness Wires
Make sure all SRS ground locations are clean, and grounds are securely fastened for optimum metal-to-
metal contact. Poor grounds can cause intermittent problems that are difficult to diagnose.
PRECAUTIONS FOR ELECTRICAL INSPECTIONS
When using electrical test equipment, insert the probe of the tester into the wire side of the connector. Do
not insert the probe of the tester into the terminal side of the connector, and do not tamper with the
connector.
Fig. 14: Inserting Probe Of Tester Into Wire Side Of Connector
Use a U-shaped probe. Do not insert the probe forcibly.
2007 Honda Element EX
2007-08 RESTRAINTS SRS (Supplemental Restraint System) - Element
Fig. 15: Identifying U-Shaped Probe
Use specified service connectors in troubleshooting. Using improper tools could cause an error in
inspection due to poor metal-to-metal contact.
SPRING-LOADED LOCK CONNECTOR
Some SRS system connectors have a spring-loaded lock.
Front Airbag Connectors
Disconnecting
To release the lock, pull the spring-loaded sleeve (A) toward the stop (B) while holding the opposite half of the
connector. Then pull the connector halves apart. Be sure to pull on the sleeve and not on the connector.
Fig. 16: Disconnecting Front Airbag Connectors
Connecting
To reconnect, hold the pawl-side connector, and press on the back of the sleeve-side connector in the direction
shown. As the two connector halves are pressed together, the sleeve (A) is pushed back by the pawl (B). Do not
touch the sleeve.
2007 Honda Element EX
2007-08 RESTRAINTS SRS (Supplemental Restraint System) - Element
Fig. 17: Connecting Front Airbag Connectors
Side Airbag Connector
Disconnecting
To release the lock, pull the spring-loaded sleeve (A) toward the stop (B) while holding the opposite half of the
connector. Then pull the connector halves apart. Be sure to pull on the sleeve and not on the connector half.
Fig. 18: Disconnecting Side Airbag Connector
Connecting
Hold both connector halves, and press them firmly together until the projection (A) of the sleeve-side connector
clicks.
2007 Honda Element EX
2007-08 RESTRAINTS SRS (Supplemental Restraint System) - Element
Fig. 19: Connecting Side Airbag Connector
OPENING THE SRS UNIT SHORTING CONNECTORS FOR DIAGNOSIS
Special Tools Required
SRS short canceller 070AZ-SAA0100
When SRS unit connectors A or C are disconnected, a short circuit is created in the connector by its own
function to prevent an airbag deployment. The circuit may need to be open sometimes when diagnosis is
performed on the system. Insert the short canceller (T/N 070AZ-SAA0100) in the specified cavities when it is
necessary to keep the circuit open for diagnosis.
NOTE:
To prevent damaging the connector cavity, insert the short canceller
straight into the cavity from the terminal side.
Before installing the short canceller, wash it with electrical contact
cleaner, then dry it with compressed air.
Do not use the short canceller if it is damaged.
Make sure to remove the short canceller before reconnection.
2007 Honda Element EX
2007-08 RESTRAINTS SRS (Supplemental Restraint System) - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст