Honda Element. Manual — part 621
Fig. 17: Identifying Reference Marks On Front Subframe And Mounting Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
28. Remove the clutch cover (A).
Fig. 18: Identifying Clutch Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
29. Remove the front engine mount (A).
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Fig. 19: Identifying Front Engine Mount
Courtesy of AMERICAN HONDA MOTOR CO., INC.
30. Support the transmission (A) with a transmission jack (B), then remove the four lower transmission
mounting bolts (C).
Fig. 20: Identifying Transmission, Transmission Jack And Lower Transmission Mounting Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
31. Pull the transmission away from the engine until the transmission mainshaft clears the clutch pressure
plate.
32. Slowly lower the transmission about 150 mm (6 in.). Check once again that all hoses and electrical wiring
are disconnected and free from the transmission, then lower it all the way.
33. Remove the rear transmission mount (A) and the rear transmission mount bracket (B).
4WD
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Fig. 21: Identifying Rear Transmission Mount And Rear Transmission Mount Bracket (4WD)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2WD
Fig. 22: Identifying Rear Transmission Mount And Rear Transmission Mount Bracket (2WD)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
34. Remove the release fork boot (A) from the clutch housing (B).
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Fig. 23: Identifying Release Fork Boot And Clutch Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
35. Remove the release fork (C) from the clutch housing by squeezing the release fork set spring (D) with
pliers. Remove the release bearing (E).
TRANSMISSION INSTALLATION
Special Tools Required
Engine support hanger, A & Reds AAR-T-12566 *
Engine hanger/adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
*These special tools are available through the Honda Tool and Equipment Program 1-888-424-6857.
1. Make sure the two dowel pins (A) are installed in the clutch housing.
Fig. 24: Identifying Dowel Pins And Clutch Housing
Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install the release fork, the release bearing, and the boot (see step 4 in CLUTCH REPLACEMENT ).
2007 Honda Element EX
2007-2008 TRANSMISSION Manual Transmission - Element
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст