Honda Odyssey 2004. Manual — part 583
−
−
−
02
03
04
YES
NO
23-274
SRS
DTC Troubleshooting (cont’d)
A
B
SRS UNIT CONNECTOR B (28P)
RED/WHT
PNK
7. Connect the special tool (jumper connector) to the
right side wire harness 2P connector.
8. Disconnect the both seat belt tensioner connectors
from the side wire harness (A).
9. Disconnect SRS unit connector B (28P) from the
SRS unit.
10. Check resistance between the No. 25 and No. 26
terminals of SRS unit connector B (28P). There
should be 0
1.0
.
Faulty front passenger’s side impact sensor
or SRS unit; replace the front passenger’s side
impact sensor (see page 23-386). If the problem is
still present, replace the SRS unit
(see page 23-384).
Go to step 11.
Wire side of female terminals
Is the r esistance as specif ied?
03/07/29 10:39:44 61S0X050_230_0274
−
−
−
*01
06
YES
NO
23-275
C852
A
SRS FLOOR SUBHARNESS 28P CONNECTOR
PNK
RED/WHT
11. Disconnect the SRS floor harness 28P connector (A)
from SRS floor subharness 28P connector C852.
12. Check resistance between the No. 28 and No. 27
terminals of the SRS floor subharness 28P
connector. There should be 0
1.0
.
Open in the SRS floor harness; replace the
SRS floor harness.
Open in the SRS floor subharness or right
side wire harness; replace the faulty harness.
Wire side of female terminals
Is the r esistance as specif ied?
03/07/29 10:39:44 61S0X050_230_0275
−
−
−
−
S0X4ASIK791000R432XFAAT20
S0X4ASIK791000R442XFAAT00
’03-04 Models
DTC 43-2x (43-20 to 43-29, 43-2A to 43-2F),
43-3x (43-30 to 43-39, 43-3A to 43-3F),
43-8x (43-80 to 43-89, 43-8A to 43-8F),
43-Bx (43-B0 to 43-B9, 43-BA to 43-BF):
’03-04 Models
DTC 44-2x (44-20 to 44-29, 44-2A to 44-2F),
44-3x (44-30 to 44-39, 44-3A to 44-3F),
44-8x (44-80 to 44-89, 44-8A to 44-8F),
44-Bx (44-B0 to 44-B9, 44-BA to 44-BF):
YES
NO
YES
NO
23-276
23-276
SRS
DTC Troubleshooting (cont’d)
Internal Failure of the Driver’s Side Impact
Sensor
Internal Failure of the Front Passenger’s Side
Impact Sensor
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Replace the driver’s side impact sensor (see
page 23-386).
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Replace the front passenger’s side impact
sensor (see page 23-386).
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
Does the SRS indicator stay on?
Does the SRS indicator stay on?
03/07/29 10:39:44 61S0X050_230_0276
−
−
−
−
S0X4AZBK791000R512XFAAT00
S0X4AZBK791000R528XFAAT00
’03-04 Models
DTC 51-2x (51-20 to 51-29, 51-2A to 51-2F),
51-4x (51-40 to 51-49, 51-4A to 51-4F):
’03-04 Models
DTC 52-8x (52-80 to 52-89, 52-8A to 52-8F),
52-9x (52-90 to 52-99, 52-9A to 52-9F):
YES
NO
YES
NO
23-277
23-277
Internal Failure of the SRS Unit
Internal Failure of the SRS Unit
NOTE: Before troubleshooting any of these DTCs, check
the battery/system voltage. If the voltage is low, repair
the charging system or replace the battery before
troubleshooting the SRS. If the battery/system voltage
is now OK, ask the customer if the battery ever went
dead.
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Replace the SRS unit (see page 23-384).
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
NOTE: Before troubleshooting any of these DTCs, check
the battery/system voltage. If the voltage is low, repair
the charging system or replace the battery before
troubleshooting the SRS. If the battery/system voltage
is now OK, ask the customer if the battery ever went
dead.
1. Erase the DTC memory (see page 23-39).
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Replace the SRS unit (see page 23-384).
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-39).
Does the SRS indicator stay on?
Does the SRS indicator stay on?
03/07/29 10:39:45 61S0X050_230_0277
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст