Mitsubishi Colt Ralliart. Manual — part 587
REAR BUMPER ASSEMBLY
EXTERIOR
51-10
REMOVAL SERVICE POINT
<<B>> RIVETS REMOVAL
AC600336AB
Rivet
Drill
Rear bumper
side lower
bracket
Use a drill (4.0 mm) to make a hole in the rivet to
break it, and then remove the rivet.
INSTALLATION SERVICE POINT
>>B<< RIVETS INSTALLATION
AC600337AB
Unit: mm
10.2
Ø4.0
Ø8.0
Use a rivet tool to attach the rivet by the following
procedure.
1. Insert the rivet into the base material rear bumper
side lower bracket.
2. Attach the rivet by using the rivet tool.
Main
Index
Group
TOC
OVERFENDER <RALLIART Version-R>
EXTERIOR
51-11
OVERFENDER <RALLIART Version-R>
ADHESIVE
M1511000501452
Application
Specified adhesive
Front / Rear/Rear door
overfender
Double-sided tape: Generic products
a: 3.0 mm width and 1.2mm thickness
b: 0.8mm thickness
REMOVAL AND INSTALLATION
M1511024700178
AC511796
5
3
1
4
AB
C
C
D
D
A
A
B
B
2
6
8
7
1
1
4
3
3
Boss
Section A – A
Section B – B
Section C – C
Section D – D
Clip
Clip
Clip
Main
Index
Group
TOC
AC511797AB
a
b
b
b
b
b
b
a
a
a
a
E
E
E
E
E
E
3
2,5,6,7
4
5
6
2
1
E
E
7
Double-sided tape: Generic products,
a: 3.0 mm width and 1.2 mm thickness
b: 0.8 mm thickness
Double-sided tape affixed location
Section E – E
Removal steps
•
Side air dam (Refer to
)
1.
Front overfender
2.
Front overfender pad
3.
Rear overfender
4.
Rear door overfender
5.
Rear overfender pad A
6.
Rear door garnish pad
7.
Rear overfender pad B
>>
A
8.
Rear door lower black-out tape
(body side)
OVERFENDER <RALLIART Version-R>
EXTERIOR
51-12
Removal steps (Continued)
Main
Index
Group
TOC
OVERFENDER <RALLIART Version-R>
EXTERIOR
51-13
INSTALLATION SERVICE POINT
>>A<<REAR DOOR LOWER BLACK-OUT
TAPE INSTALLATION
1. INSTALLATION POSITION
AC600859
AB
Door opening line
43.6 mm
A
A
Rear door lower
black-out tape
Black-out tape
1.7 mm
Rear overfender
installation hole
Section A – A
Rear door
overfender
Rear
overfender
CAUTION
• The ambient temperature should be 20 to
38
°C. Ensure that the working area is clean.
• If ambient temperature is less than 15°C, heat
the black-out tape and application surface to
a temperature of 20 to 30
°C.
• Be careful that air bubbles are not formed
under the black-out tape.
2. INSTALLATION PROCEDURE
(1) Wipe the black-out tape application surface
and clean it with a rag moistened with
isopropyl alcohol.
(2) Remove backing paper from the black-out
tape, and apply the tape to the specified
position.
(3) Remove an application tape from the black-out
tape.
Main
Index
Group
TOC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст