Mitsubishi Colt Ralliart. Manual — part 593
WINDSHIELD WIPER AND WASHER
EXTERIOR
51-34
NOTE: For removal and installation of the wiper and
washer switch, refer to GROUP 54A, Column switch
.
REMOVAL SERVICE POINTS
<<A>>WASHER MOTOR REMOVAL
AC402414AB
Washer motor
Washer tank
Flat-tipped
screwdriver
Insert a flat-tipped screwdriver wrapped with protec-
tive tape between the washer tank and the lower
outer side of the washer motor. Pry out the washer
motor.
Main
Index
Group
TOC
WINDSHIELD WIPER AND WASHER
EXTERIOR
51-35
INSPECTION
M1511019101281
WINDSHIELD WASHER FLUID EJECTION
CHECK
AC402352
AB
335
600
367
131
160
175
129
145
105
100
140
70
265
283
70
215
110
125
255
95
270
140
75
180
155
Windshield
washer nozzle
perpendicular
Windshield
washer nozzle
perpendicular
<Right>
<Left>
Unit: mm
Ceramic line terminal
Windshield washer nozzle
Move the nozzle to adjust the position so that the
spray is in the area shown in the illustration.
Main
Index
Group
TOC
REAR WIPER AND WASHER
EXTERIOR
51-36
REAR WIPER AND WASHER
TROUBLESHOOTING
M1511020000401
The rear wiper washer is controlled by the Smart
Wiring System (SWS). For troubleshooting, refer to
GROUP 54B, Troubleshooting
or GROUP
54C, Troubleshooting
ON-VEHICLE SERVICE
M1511000801033
OPERATION CHECK OF REVERSE
GEAR-LINKED OPERATION OF THE
REAR WIPER
1. When the selector lever is moved to the "R" posi-
tion with the rear wiper switch at the "INT" posi-
tion, the wiper should operate twice or three
times at low speed after approximately one sec-
ond.
2. If not, carry out the troubleshooting. (Refer to
GROUP 54B, Troubleshooting
GROUP54C, Troubleshooting
WASHER MOTOR INSPECTION (REAR
WASHER)
2 1
AC405555
1. Check the washer fluid level of washer tank
located at front right corner, and refill fluid if
necessary.
2. Remove the front part of splash shield (RH).
3. Disconnect the washer motor connector.
4. Connect the battery to the washer motor
connector as shown. Check that the washer motor
delivers washer strongly.
Main
Index
Group
TOC
REAR WIPER AND WASHER
EXTERIOR
51-37
REAR WIPER AND WASHER
REMOVAL AND INSTALLATION
M1511008500505
AC510260
4
AB
3
2
1
6
5
5.4 ± 1.4 N·m
7.4 ± 1.4 N·m
A
A
1
Claw
Tailgate outer
panel
Claw
Section A – A
Washer tank assembly removal
•
Washer tank (Refer to
).
•
Rear washer nozzle removal steps
•
Tailgate spoiler (Refer to
•
High-mounted stop lamp assembly
(Refer to GROUP 54A, High-mounted
stop lamp
).
1. Rear washer nozzle assembly
Rear wiper blade removal steps
2. Rear wiper blade assembly
>>
A
<< 3. Rear wiper blade
Rear wiper motor removal steps
>>
B
<< 4. Rear wiper arm blade assembly
•
Tailgate trim (Refer to GROUP 52A,
Tailgate trim
).
5. Rear wiper motor assembly
Rear washer hose removal steps
•
Cowl side trim, front scuff plate, rear
scuff plate, quarter trim (Refer to
GROUP 52A, Interior trim
•
Tailgate trim (Refer to GROUP 52A,
Tailgate trim
).
6. Rear washer hose
NOTE: For removal and installation of the wiper and
washer switch, refer to GROUP 54A, Column switch
Main
Index
Group
TOC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст