Mitsubishi 380. Manual — part 925
RADIO WITH CD PLAYER
CHASSIS ELECTRICAL
54A-234
ANTENNA
REMOVAL AND INSTALLATION
M1544002900712
16DB563A
1
2
REMOVAL STEPS
•
REAR SEAT CUSHION ASSEMBLY
(GROUP 52A, REAR SEAT ASSEMBLY
.)
•
REAR SCUFF PLATE, FRONT DOOR
OPENING TRIM (CENTER PILLAR
SIDE), REAR DOOR OPENING TRIM
(CENTER PILLAR SIDE), FRONT
SCUFF PLATE (REFER TO GROUP
52A, TRIMS
.)
•
FRONT SEAT BELT UPPER AND
LOWER CONNECTION (REFER TO
GROUP 52A, FRONT SEAT BELT
.)
•
CENTER PILLAR TRIM LOWER, COWL
SIDE TRIM (REFER TO GROUP 52A,
TRIMS
.)
•
GEARSHIFT LEVER PANEL, FRONT
BOX, FLOOR CONSOLE ASSEMBLY
(REFER TO GROUP 52A, FLOOR
CONSOLE ASSEMBLY
•
FRONT SEAT ASSEMBLY (REFER TO
GROUP 52A, FRONT SEAT ASSEMBLY
•
FOOT REST
•
FLOOR CARPET
•
RADIO AND CD PLAYER OR RADIO,
CD PLAYER AND CD CHANGER
(REFER TO
•
REAR SEATBACK ASSEMBLY (REFER
TO GROUP 52A, REAR SEAT
ASSEMBLY
.)
REMOVAL STEPS (Continued)
DEFOGGER
CHASSIS ELECTRICAL
54A-235
DEFOGGER
GENERAL DESCRIPTION
M1543000100353
Defogger operation
• The defogger relay turns ON if the defogger
switch built-in the A/C-ECU is turned ON when
the ignition switch is in the "ON" position. When
the defogger relay turns ON, power is supplied to
the defogger and the defogger is activated. The
defogger comes with a timer function that causes
the defogger switch to automatically turn OFF in
about 17 minutes after the defogger switch is
turned ON.
DEFOGGER DIAGNOSIS
M1543000701068
The defogger is controlled by the A/C-ECU. For trou-
bleshooting, refer to GROUP 55, Auto A/C Diagnosis
− Symptom Chart
.
ON-VEHICLE SERVICE
PRINTED-HEATER LINES CHECK
M1543001800333
1. Run the engine at 2,000 r/min. Check the heater element
with the battery at full.
2. Turn "ON" the rear window defogger switch. Measure the
heater element voltage with an ohmmeter at the rear
window glass centre A. Condition is good if it indicates about
6 V.
•
REAR DOOR OPENING TRIM (REAR
PILLAR SIDE), REAR PILLAR TRIM,
REAR SHELF SPEAKER GARNISH,
REAR SHELF TRIM (REFER TO
GROUP 52A, TRIMS
.)
1. ANTENNA FEEDER CABLE (REAR
PILLAR SIDE)
2. ANTENNA FEEDER CABLE WITH
AMPLIFIER
REMOVAL STEPS (Continued)
AC002357AC
A
DEFOGGER
CHASSIS ELECTRICAL
54A-236
3. If 12 V is indicated at A, there is a break in the negative
terminals from A. Move the test probe slowly to the negative
terminal to detect where voltage changes suddenly (0V).
4. If 0 V is indicated at A, there is a break in the positive
terminals from A. Defect where the voltage changes
suddenly (12 V) in the same method described above.
ACX00813
NORMAL CHARACTERSTIC CURVE
ABNORMAL CHARACTERSTIC CURVE
VOLTAGE
A (CENTER POINT)
APPROXIMATELY
6 V
NEGATIVE
TERMINAL
PRINTED
HEATER
LINE
POSITIVE
TERMINAL
NEGATIVE
TERMINAL
PRINTED
HEATER
LINE
POSITIVE
TERMINAL
OPENCIRCUIT
POINT
VOLTAGE
AC
DEFOGGER
CHASSIS ELECTRICAL
54A-237
REAR WINDOW DEFOGGER SWITCH
REMOVAL AND INSTALLATION
M1543006200325
Refer to GROUP 55, Heater Control Assembly and
A/C Switch
INSPECTION
M1543019502537
DEFOGGER RELAY CONTINUITY CHECK
BATTERY VOLTAGE
CONNECT
TESTER
BETWEEN:
SPECIFIED
CONDITION
Not applied
4-5
Open Circuit
• Connect terminal 1
to the positive
battery terminal
• Connect terminal 3
to the negative
battery terminal
4-5
Less than 2 ohms
16DB547A
4
5
1
3
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст