Mitsubishi 380. Manual — part 772
GENERAL DESCRIPTION
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-12
CONFIGURATION DIAGRAMS
52DB002A
AC304366
AC304353
AC304363
DASH PANEL
STEERING COLUMN
FLOOR AND ROOF
ENGINE ROOM
C-307
A-23
C-305
A-27
C-110
D-33
D-32
D-35
D-20
D-21
D-24
37DB228A
C-121
Y
5
3
FLOOR WIRING
HARNESS
INSTRUMENT PANEL
WIRING HARNESS
37DB232A
FLOOR
WIRING
HARNESS
4
Y
2
15
D-24
D-32
ROOF
WIRING
HARNESS
D-26
D-27
FLOOR AND ROOF
GENERAL DESCRIPTION
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-13
CIRCUIT DIAGRAM
• Refer to circuit diagrams GROUP-
• Refer to configuration diagrams GROUP-
WARNING
•
Do not repair, splice, or modify the SRS wiring (except for specific repairs to the instru-
ment panel wiring harness and the floor wiring harness shown on
): replace the
wiring if necessary, after reading and following all precautions and procedures in this
manual.
•
Do not use an analog ohmmeter to check the SRS wiring or components; use only the
special tools (refer to
) and a digital multi-meter (refer to
).
CAUTION
Improper services cause the system to be inoperative. Do not disassemble or tamper with the SRS
components to prevent the serious injury.
A-23 (Y)
FRONT IMPACT SENSOR (LH)
A-27 (Y)
FRONT IMPACT SENSOR (RH)
C-101
COMBINATION METER (FOR SRS
WARNING LIGHT)
C-110 (Y)
AIR BAG MODULE (FRONT
PASSENGER’S SIDE)
D-26 (Y)
SRS-ECU
C-121 (Y)
SRS-ECU
D-27 (Y)
SRS-ECU
C-125 (B)
DATA LINK CONNECTOR
C-305 (Y)
AIR BAG MODULE (SQUIB)
(DRIVER’S SIDE)
C-307 (Y)
CLOCK SPRING
D-20
SIDE IMPACT SENSOR (LH)
D-21 (B)
SEAT BELT PRE-TENSIONER
(LH)
D-24 (R)
SIDE-AIRBAG MODULE (SQUIB)
(LH)
D-32 (R)
SIDE-AIRBAG MODULE (SQUIB)
(RH)
D-33 (B)
SEAT BELT PRE-TENSIONER
(RH)
D-35
SIDE IMPACT SENSOR (RH)
GENERAL DESCRIPTION
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-14
COMPONENT LOCATION
AC306289
52DB003A
AC305250
AC305035
SIDE IMPACT SENSOR
FRONT IMPACT SENSOR
FRONT IMPACT
SENSOR
CENTER
PILLER
SIDE IMPACT
SENSOR
GENERAL DESCRIPTION
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-15
NOTE: The illustration above shows the front impact sensor (RH) and the side impact sensor (RH). The posi-
tion of the front impact sensor (LH) and the side impact sensor (LH) is symmetrical to this.
52DB003A
DATA LINK CONNECTOR
SRS-ECU
SRS-ECU
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст