Mitsubishi 380. Manual — part 219
REFRIGERANT LINE
HEATER, AIR CONDITIONING AND VENTILATION
55-172
O-RING AND PIPE SERVICE POINT
.
O-RING AND PIPE FITTING
1. The following o-rings and pipe fittings are used in this air
conditioning system.
2.Ensure the correct size o-ring is installed as required during
service of system.
3.Two types of pipe fittings are used in this air conditioning
system.
.
25DB167A
25DB168A
REFRIGERANT LINE
HEATER, AIR CONDITIONING AND VENTILATION
55-173
O-RING REPLACEMENT
1.Removal- use a wooden toothpick or plastic awl to remove
o-ring without damaging the tube.
2.Installation- lubricate o-ring with ND-Oil 8, roll the
new o-ring into captured position.
.
PIPE JOINT PRECAUTIONS
1. Before making any hose and tube connections, always
apply ND-Oil 8 compressor oil to o-ring.
CAUTION
Avoid applying oil in areas with acrylic resin or ABS plastic
as it causes enviromental stress cracking to these resins.
2. Ensure the connecting parts are free of foreign material.
25DB169A
25DB170A
25DB171A
25DB172A
REFRIGERANT LINE
HEATER, AIR CONDITIONING AND VENTILATION
55-174
3. Ensure a complete mating of joint before tightening the bolts
or nut.
4. Tighten the joint to the specific torque. For the nut joint, pay
special attention to following cautions.
CAUTION
Always use two wrenches to prevent the tubes from twist-
ing.
Pipes will rotate 15 - 20 clockwise during tightening, so
ensure final position is the correct location.
When finally tightening the pipes, do not rotate the fixed
side(female side).
25DB173A
25DB174A
DUCTS
HEATER, AIR CONDITIONING AND VENTILATION
55-175
DUCTS
REMOVAL AND INSTALLATION
M1553001000275
25DB141A
2
1
1
3
4
5
DEFROSTER NOZZLE AND
DISTRIBUTION DUCT REMOVAL
STEPS
•
INSTRUMENT PANEL (REFER TO
GROUP 52A
).
1.
VENTILATOR AIR DISTRIBUTION
DUCT
2.
SIDE DEFROSTER DUCT
3.
DEFROSTER NOZZLE
FOOT DUCT AND REAR HEATER
DUCT REMOVAL STEPS
•
FRONT SEAT ASSEMBLY
(REFER TO GROUP 52A, FRONT
SEAT ASSEMBLY
•
FRONT SCUFF PLATE, COWL
SIDE TRIM (REFER TO GROUP
52A, TRIMS
.)
•
FLOOR CARPET PEELING
•
FLOOR CONSOLE ASSEMBLY
(REFER TO GROUP 52A, FLOOR
CONSOLE ASSEMBLY
.)
•
TRUNK LID RELEASE HANDLE
COVER (REFER TO GROUP 42,
TRUNK LID
.)
•
ACCELERATOR STOPPER
(REFER TO GROUP 17,
ACCELERATOR CABLE AND
PEDAL
4.
REAR HEATER DUCT A
5.
REAR HEATER DUCT B
FOOT DUCT AND REAR HEATER
DUCT REMOVAL STEPS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст