Mitsubishi 380. Manual — part 568
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
MULTIPORT FUEL INJECTION (MFI)
13A-364
STEP 11. Measure the power supply voltage at crankshaft
position sensor harness side connector B-119.
(1) Disconnect the connector B-119 and measure at the
harness side.
(2) Turn the ignition switch to the "ON" position.
(3) Measure the voltage between terminal No. 3 and ground.
• Voltage should be 4.9 - 5.1 volts.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the measured voltage between 4.9 and 5.1volts?
YES : Go to Step 13.
NO : Go to Step 12.
AK303123
1
2
3
CRANKSHAFT
POSITION
SENSOR
AB
CRANKSHAFT
SPROCKET
CONNECTOR: B-119
B-119 (B)
HARNESS
CONNECTOR:
COMPONENT SIDE
AK303127AB
2 1
3
B-119 HARNESS
CONNECTOR:
COMPONENT SIDE
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
MULTIPORT FUEL INJECTION (MFI)
13A-365
STEP 12. Check harness connector B-20 at ECU for
damage.
Q: Is the harness connector in good condition?
YES : Repair harness wire between ECU connector B-20
(terminal No. 25) and crankshaft position sensor
connector B-119 (terminal No. 3) because of open
circuit or short circuit to ground. Then go to Step 18.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then go to Step 18.
16DB400A
COVER
ENGINE
CONTROL
UNIT
AIR
CLEANER
AK303123
1
2
3
CRANKSHAFT
POSITION
SENSOR
AB
CRANKSHAFT
SPROCKET
CONNECTOR: B-119
B-119 (B)
HARNESS
CONNECTOR:
COMPONENT SIDE
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
MULTIPORT FUEL INJECTION (MFI)
13A-366
STEP 13. Check for continuity at crankshaft position
sensor harness side connector B-119.
(1) Disconnect the connector B-119 and measure at the
harness side.
(2) Check for the continuity between terminal No. 1 and
ground.
• Should be less than 2 ohms.
Q: Does continuity exist?
YES : Go to Step 16.
NO : Go to Step 14.
AK303123
1
2
3
CRANKSHAFT
POSITION
SENSOR
AB
CRANKSHAFT
SPROCKET
CONNECTOR: B-119
B-119 (B)
HARNESS
CONNECTOR:
COMPONENT SIDE
AK303128 AB
2 1
3
B-119 HARNESS
CONNECTOR:
COMPONENT SIDE
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
MULTIPORT FUEL INJECTION (MFI)
13A-367
STEP 14. Check harness connector B-20 at ECU for
damage.
Q: Is the harness connector in good condition?
YES : Go to Step 15.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then go to Step 18.
16DB400A
COVER
ENGINE
CONTROL
UNIT
AIR
CLEANER
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст