Mitsubishi Outlander (2003+). Manual — part 427
SPEAKER
CHASSIS ELECTRICAL
54A-103
SPEAKER
REMOVAL AND INSTALLATION
M1544002600517
AC102825 AD
1
2
3
4
6
5
1.5 ± 0.5 N·m
1.5 ± 0.5 N·m
Front door speaker removal
steps
1.
Front door speaker garnish
2.
Front door speaker
Rear door speaker removal
steps
3.
Rear door speaker garnish
4.
Rear door speaker
Tweeter removal steps
5.
Delta cover (Refer to GROUP 51,
Door Mirror
.)
6.
Tweeter
ANTENNA
CHASSIS ELECTRICAL
54A-104
ANTENNA
ANTENNA
REMOVAL AND INSTALLATION
M1544002900585
Pre-removal and Post-installation Operation
•
Front pillar trim, Quarter trim upper, Quarter trim lower,
Center pillar trim lower, Center pillar trim upper (Refer to
GROUP 52A, Trim
•
Assist Grip, Headlining (Refer to GROUP 52A, Headlining
•
Instrument Panel Removal and Installation (Refer to
GROUP 52A, Instrument Panel
<LHD> or
<RHD>.)
AC300925 AB
1
3
2
4
3.0 ± 1.0 N·m
Removal steps
1. Rod assembly
2. Antenna nut
3. Base
4. Antenna feeder assembly
Removal steps (Continued)
REAR WINDOW DEFOGGER
CHASSIS ELECTRICAL
54A-105
REAR WINDOW DEFOGGER
GENERAL INFORMATION
M1543000100397
Rear Defogger operation
The defogger relay turns ON if the defogger switch
built-in the A/C-ECU is turned ON when the ignition
switch is in the "ON" position. When the defogger
relay turns ON, power is supplied to the defogger
and the defogger is activated. The defogger comes
with a timer function that causes the defogger switch
to automatically turn OFF in about 11 minutes
(manual A/C) or about 20 minutes (automatic A/C)
after the defogger switch is turned ON.
TROUBLESHOOTING
M1543000701110
The rear window defogger is controlled by the
A/C-ECU. For troubleshooting, refer to GROUP 55A,
Troubleshooting
or GROUP 55B,
Troubleshooting
ON-VEHICLE SERVICE
PRINTED HEATER LINES CHECK
M1543001800355
1. Run engine at 2,000 r/min. Check heater element
with battery at full.
2. Turn "ON" rear window defogger switch. Measure
heater element voltage with circuit tester at rear
window glass centre A. Condition is good if it
indicates about six volts.
3. If 12 volts is indicated at A, there is a break in the
negative terminals from A. Move test bar slowly to
negative terminal to detect where voltage
changes suddenly (0volts).
4. If 0 volts is indicated at A, there is a break in the
positive terminals from A. Defect where the
voltage changes suddenly (12 volts) in the same
method described above.
REAR WINDOW DEFOGGER SWITCH
REMOVAL AND INSTALLATION
M1543006200347
Refer to GROUP 55A, Heater Control Assembly and
Blower Switch Assembly
INSPECTION
M1543019502656
DEFOGGER RELAY CHECK
ACX00813
Normal characterstic curve
Abnormal characterstic curve
A (Center point)
Approximately 6 V
Negative
terminal
Print heater line
Positive
terminal
Open circuit point
Voltage
AC
Voltage
Negative
terminal
Print heater line
Positive
terminal
Battery voltage
Tester
connection
Specified
condition
Not supplied
4
−
5
Open circuit
•
Connect terminal
1 to the positive
battery terminal
•
Connect terminal
3 to the negative
battery terminal
4
−
5
Less than 2
ohms
AC212486
OFF
ON
3
4
5
1
Defogger relay
Junction block
AB
NOTES
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст