Mitsubishi Grandis. Manual — part 20
TROUBLE SYMPTOM CHART
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-77
Rear wiper and washer
Rear wiper does no not work at all.
H-1
The rear wiper does not stop at the
specified park position.
H-2
When the shift lever is moved to "R"
position during the rear wiper operation,
the rear wiper does not operate at the
continuous mode. <A/T>
H-3
When the shift lever is moved to "R"
position during the rear wiper operation,
the rear wiper does not operate at the
continuous mode. <M/T>
The rear washer does not work.
H-4
Headlamp washer
The headlamp washer does not work.
I-1
Electric retractable remote
controlled door mirror
Electric retractable remote controlled door
mirror does not work at all.
J-1
Left or right side electric retractable remote
controlled door mirror does not work at all.
J-2
Electric retractable remote controlled door
mirror timer function does not at all.
J-3
Vehicle speed-dependent unfolding
function does not work normally.
J-4
Ignition key cylinder
illumination lamp
The ignition key cylinder illumination lamp
does not illuminate/extinguish normally.
K-1
Seat belt warning lamp
The seat belt warning lamp does not flash
normally.
L-1
Symptom
Inspection
procedure
number
Reference
page
TROUBLE SYMPTOM CHART
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-78
Headlamp and tail lamp
The tail lamps do not illuminate normally.
M-1
The low-beam headlamps do not illuminate
normally.
M-2
The high-beam headlamps do not
illuminate normally.
M-3
The high-beam and low-beam headlamps
do not illuminate when the passing switch
is operated.
M-4
The headlamp automatic-shutdown
function does not work normally.
M-5
Any of tail lamps, position lamps or licence
plate lamp does not illuminate.
M-6
The headlamp(s) do not illuminate.
M-7
The high-beam indicator lamps does not
illuminate.
M-8
Daytime running lamp function does not
work normally.
M-9
The headlamps do not illuminate when the
lighting switch is at "TAIL" or "PASSING"
position, but illuminate only at low beam
when the switch is at "HEAD" position.
However, the headlamps do not illuminate
at high beam.
M-10
Flasher timer
The turn-signal lamps do not illuminate.
N-1
The hazard warning lamps do not
illuminate.
N-2
Any of the turn-signal lamps does not
illuminate.
N-3
The turn-signal indicator lamp does not
illuminate.
N-4
Fog lamp
The front fog lamps do not illuminate
normally.
O-1
The rear fog lamps do not illuminate
normally.
O-2
Any of the front fog lamps does not
illuminate normally.
O-3
The front fog lamps indicator does not
illuminate normally.
O-4
The rear fog lamps indicator does not
illuminate normally.
O-5
Symptom
Inspection
procedure
number
Reference
page
CHECK TROUBLE BY USING THE INPUT SIGNAL CHECK
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-79
CHECK TROUBLE BY USING THE INPUT SIGNAL CHECK
M1549024200299
<PULSE CHECK>
If a problem is found in the Service Data or Pulse
Check inspection, observe the table below.
Interior lamp
The interior lamps (room ramp, rear
personal lamps, door lamps, luggage
compartment lamp, key illumination lamp)
does not illuminate or extinguish normally.
P-1
The room lamp does not illuminate
normally.
P-2
The rear personal lamp does not illuminate
normally.
P-3
The luggage compartment lamp does not
illuminate normally.
P-4
The door lamp does not illuminate
normally.
P-5
Interior lamp automatic shutoff function
does not work normally. <Vehicles with
keyless entry system>
P-6
The door-ajar warning lamp does not
illuminate/extinguish normally.
P-7
Symptom
Inspection
procedure
number
Reference
page
Symptom
Inspection
procedure
number
Reference
page
The ignition switch (ACC) signal is not received.
Q-1
The ignition switch (IG1) signal is not received.
Q-2
The back-up lamp switch signal is not received. <M/T>
Q-3
The front fog lamp switch signal is not received.
Q-4
The driver's door switch signal is not received. <LH drive vehicles>
Q-5
The driver's door switch signal is not received. <RH drive vehicles>
CHECK TROUBLE BY USING THE INPUT SIGNAL CHECK
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-80
Column switch (lighting and
turn-signal lamp and headlamp
washer switch)
The tail lamp switch signal is not
received.
Q-6
The headlamp switch signal is not
received.
The dimmer switch signal is not
received.
The passing switch signal is not
received.
The turn-signal lamp switch (LH)
signal is not received.
The turn-signal lamp switch (RH)
signal is not received.
The headlamp washer switch signal
is not received.
Column switch (windshield
wiper/washer and rear wiper washer
switch)
The windshield mist wiper switch
signal is not received.
Q-7
The windshield intermittent wiper
switch signal is not received.
The windshield low-speed wiper
switch signal is not received.
The windshield high-speed wiper
switch signal is not received.
The windshield washer switch signal
is not received.
The rear wiper switch signal is not
received.
The rear washer switch signal is not
received.
The windshield intermittent wiper
volume signal is not received.
Q-8
When the power window main switch is operated, the switch signals are not
received.
Q-9
When the sunroof switch is operated, the switch signals are not received.
Q-10
The key reminder switch signal is not received.
Q-11
The hazard warning lamp switch signal is not received.
Q-12
The rear fog lamp switch signal is not received.
Q-13
All the door switch signals are not received.
Q-14
The driver's door lock actuator switch signal is not received. <LH drive
vehicles>
Q-15
The driver's door lock actuator switch signal is not received. <RH drive
vehicles>
Symptom
Inspection
procedure
number
Reference
page
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст