Mitsubishi Grandis. Manual — part 2
GENERAL INFORMATION
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-5
GENERAL INFORMATION
M1549000100522
The exclusive signal lines for transmitting the
multi-distribution data are connected as follows
between the ETACS-ECU, column switch
(incorporated inside the column-ECU), front-ECU,
power window main switch (incorporated inside the
power window-ECU), power window sub switches
(incorporated inside the power window-ECU), and
sunroof motor assembly for internal communication.
AC311854
ETACS-ECU
A/C-ECU
SRS-ECU
Combination meter
ABS-ECU <without ASC>
ASC-ECU <with ASC>
Centre display
Steering wheel sensor
Engine-A/T-ECU <A/T>
Engine-ECU <M/T>
Sunroof motor assembly
Power window main switch
Power window sub switch
(Front)
Power window sub switch
(Rear LH)
Power window sub switch
(Rear RH)
Column switch
Front-ECU
AB
: Bidirectional communication
: Unidirectional communication
CAN communication
SWS communication
Communication
between doors
or
or
GENERAL INFORMATION
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-6
BUZZER
LAMP REMINDER BUZZER FUNCTION
When the ignition key is removed and then the
driver's door is opened with turning ON the tail lamp
or the headlamp, the buzzer sounds continuously to
alert the driver that the lamp is still ON.
However, if the tail lamp or the headlamp is turned off
by the headlamp automatic-shutdown off function,
the buzzer does not sound.
AC208400
ON
OFF
ON (Open)
OFF (Closed)
ON (Buzzer
sounds)
OFF (Buzzer
does not sound)
Tail lamp or
headlamp
Driver's
door
switch
Buzzer
output
AC
GENERAL INFORMATION
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-7
SEAT BELT WARNING BUZZER
FUNCTION
AC309952
ON
OFF
ON (Unfastened)
OFF (Fastened)
Ignition switch (IG1)
Seatbelt switch
(Driver's side)
ON (Unfastened)
OFF (Fastened)
Seatbelt switch
(Passenger's side)
8 km/h
0 km/h
Vehicle speed
3 km/h
ON
OFF
b: approximately 0.5 second
b: approximately 0.5 second
d: 1 second
AB
b
b
b
b
b
b
c
c
a
b
b
d
d
d
d
d
d
e
12 cycles
1 cycle
ON (Buzzer
sounds)
OFF (Buzzer
does not
sound )
Seatbelt buzzer
output
Seatbelt buzzer
output
Seatbelt buzzer
output
ON
OFF
t1
t2: approximately 0.5 second
t1: approximately 0.2 second
t1
t1
t2
Seat occupancy
sensor
ON (Seat
occupied)
OFF (Seat not
occupied)
60 seconds or more
e: approximately 3 seconds
a: 6 seconds
c: 10 seconds
12 cycles
12 cycles
12 cycles
12 cycles
12 cycles
GENERAL INFORMATION
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-8
When the ignition switch is turned ON with the
driver’s seat belt unbuckled, the ETACS-ECU
triggers a warning buzzer (repetition of a short beep
sound) for 6 seconds to notify the driver that the seat
belt is not fastened.
When the ETACS-ECU detects that the vehicle
speed signal sent from the combination meter
through CAN communication exceeds 8 km/h and
the driver’s seat belt buckle is not engaged, it will
trigger a warning buzzer (repetition of 5-second ON
and 2.8-second OFF for 12 cycles). The
ETACS-ECU stops the buzzer when the driver’s seat
belt buckle is engaged while the warning cycle is ON.
DOOR AJAR WARNING BUZZER
FUNCTION <THE INITIAL CONDITION:
WITH FUNCTION>
If the vehicle speed exceeds 8 km/h with the
door-ajar, the buzzer sounds (pings eight times) to
alert the driver that the door is not properly closed.
NOTE: Availability of the door-ajar alarm function
can be selected by the customize function.
Turn-signal lamp buzzer function <the
initial condition: Without function>
ETACS-ECU buzzer sounds simultaneously with the
blinks of the turn signal lamp and the hazard lamp.
AC309677
ON
(Any one open) ON
OFF
(All closed) OFF
8 km/h
0km/h
Ignition switch
Door switch
Speed vehicle
Buzzer output
(Buzzer sounds)ON
(Buzzer does not sound) OFF
AB
AC309772
Turn signal
lamp switch
(RH) OFF
ON
Turn signal
lamp
(RH) OFF
ON
OFF
ON
Turn signal
lamp (LH)
Turn signal
lamp switch
(LH)
OFF
ON
Hazard lamp
switch
OFF
ON
Hazard lamp
OFF
ON
AB
ON (Buzzer
sounds)
OFF (Buzzer
does not sound)
Buzzer
output
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст