Mitsubishi Grandis. Manual — part 935
TROUBLESHOOTING
TRACTION CONTROL/ACTIVE STABILITY CONTROL SYSTEM
35C-65
body earth.
OK: System voltage
Q: Is the check result normal?
YES :
Go to Step 6.
NO :
Go to Step 5.
TROUBLESHOOTING
TRACTION CONTROL/ACTIVE STABILITY CONTROL SYSTEM
35C-66
STEP 5. Check the harness wire between
TCL/ASC-ECU connector A-04 terminal 6 and G
and yaw rate sensor connector C-117 terminal 1.
TROUBLESHOOTING
TRACTION CONTROL/ACTIVE STABILITY CONTROL SYSTEM
35C-67
NOTE: After inspecting the TCL/ASC-ECU
connector A-04, intermediate connector A-16 and G
and yaw rate sensor connector C-117, inspect the
wire. If any of these connector is damaged, repair or
replace it. Then go to Step 10.
Q: Is the check result normal?
YES :
Go to Step 9.
NO :
Repair it and go to Step 10.
AC312621
Oil reservoir
Connector: A-04
AB
A-04
Hydraulic unit
(with built-in TCL/ASC-ECU)
A-04 Harness connector
(harness side)
AC312624AF
Connector: C-117
<L.H.drive vehicles>
C-117
C-117 Harness connector
(harness side)
AC312625AF
Connector: C-117
<R.H.drive vehicles>
C-117
C-117 Harness connector
(harness side)
AC312617AC
Connector: A-16
<L.H.drive vehicles>
A-16(B)
AC312619AC
Connector: A-16
<R.H.drive vehicles>
A-16(B)
TROUBLESHOOTING
TRACTION CONTROL/ACTIVE STABILITY CONTROL SYSTEM
35C-68
STEP 6. Resistance measurement the harness
wire between G and yaw rate sensor connector
C-117 terminal 5 and ground.
(1) Disconnect the G and yaw rate sensor connector
C-117, and measure at the harness side
connector.
(2) Measurement the resistance between terminal 5
and ground.
OK: 2 ohms or less
Q: Is the check result normal?
YES :
Go to Step 8.
NO :
Go to Step 7.
AC313186
AC
Connector: C-117
<L.H.drive vehicles>
C-117
C-117 Harness connector
(harness side)
AC313188AC
Connector: C-117
<R.H.drive vehicles>
C-117
C-117 Harness connector
(harness side)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст