Mitsubishi Grandis. Manual — part 118
INPUT SIGNAL PROCEDURES
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-469
Inspection Procedure Q-14: All the door switch signals are not received.
CAUTION
Whenever the ECU is replaced, ensure that the
input signal circuit is normal.
Door Switches Input Circuit <LHD>
DOOR
SWITCH
(FRONT: RH)
DOOR
SWITCH
(REAR: RH)
DOOR
SWITCH
(FRONT: LH)
DOOR
SWITCH
(REAR: LH)
ETACS-ECU
Wire colour code
B : Black LG : Light green G : Green L : Blue W : White Y : Yellow SB : Sky blue
BR : Brown O : Orange GR : Gray R : Red P : Pink V : Violet
J/B SIDE
TAILGATE
SWITCH
INPUT SIGNAL PROCEDURES
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-470
COMMENTS ON TROUBLE SYMPTOM
Input signals from all the door switches and tailgate
switch are used to operate the functions below. If the
signal(s) are abnormal, these functions will not work
normally.
• Keyless entry system
• Room lamps
POSSIBLE CAUSES
• Malfunction of the door switches
• Malfunction of the tailgate switch
• Malfunction of the ETACS-ECU
• Damaged harness wires and connectors
DIAGNOSTIC PROCEDURE
Step 1. Pulse check
Check the input signal from the driver's door switch.
OK: The MUT-III sounds or the voltmeter
needle fluctuates.
Q: Is the check result normal?
YES :
Go to Step 2.
NO :
Refer to inspection procedure Q-5 "The
driver's door switch signal is not received
<LH drive vehicles>
drive vehicles>
Door Switches Input Circuit <RHD>
DOOR
SWITCH
(FRONT: LH)
DOOR
SWITCH
(REAR: RH)
DOOR
SWITCH
(FRONT: RH)
DOOR
SWITCH
(REAR: LH)
ETACS-ECU
Wire colour code
B : Black LG : Light green G : Green L : Blue W : White Y : Yellow SB : Sky blue
BR : Brown O : Orange GR : Gray R : Red P : Pink V : Violet
J/B SIDE
TAILGATE
SWITCH
System switch
Check conditions
Driver's door switch
When the driver's door is
opened
INPUT SIGNAL PROCEDURES
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-471
Step 2. Connector check: D-17 (front: LH), D-02
(front: RH), D-08 (rear: RH) or D-13 (rear: LH)
door switch connectors or G-18 tailgate switch
connector, and C-219, C-220 and C-221
ETACS-ECU connector
INPUT SIGNAL PROCEDURES
SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR
54B-472
AC312054
Connectors: D-13, D-17
D-13
AB
D-17
Harness side
D-17
D-13
<LHD>
AC312054
Connectors: D-13, D-17
D-13
AC
D-17
Harness side
D-17
D-13
<RHD>
AC312052
Connectors: D-02, D-08
D-02
AB
D-08
<LHD>
D-02
D-08
Harness side
AC312059
Connectors: D-02, D-08
D-02
AB
D-02
D-08
D-08
Harness side
<RHD>
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст