Mitsubishi Lancer Evolution VI. Manual — part 109
CHASSIS ELECTRICAL –
Front Fog Lamp
54-40
Standard values:
Vertical direction
2
°
(349 mm) below horizontal line
(H)
Horizontal direction
3
°
(524 mm) leftward from
vertical line (V)
Caution:
(1) Perform aiming adjustments, one light at a time,
with the other headlamp disconnected so as not
to be lit unless circumstances compel otherwise.
When reconnecting the headlamps, be careful not
to upset their aim. Do not leave the headlamps
on for any longer than 3 minutes if their outer
lenses are covered with a surface covering
impervious to light.
(2) Do not mask the outer lenses by taping or in any
other way.
(3) Aiming adjustment must be completed with the
aiming adjustment screws turned in the tightening
direction.
FOG LAMP BULB REPLACEMENT
1.
Remove the fog lamp.
2.
Remove the cover.
3.
Unhook the spring which secures the bulb and then
replace the bulb.
Caution
(1) Do not touch the surface of the bulb with hands
or dirty gloves. If the surface does become dirty,
clean it with alcohol or thinner, and let it dry
thoroughly before installing.
(2) To prevent the clouding of lens and ingress of
water into the lamp unit, install the socket cover
correctly.
Lamp center
Vertical
direction
High
intensity
zone
center
(optical
axis)
High intensity zone
Horizontal direction
V
H
Cover
CHASSIS ELECTRICAL –
Front Fog Lamp
ILL
ILL
54-41
FOG LAMP
REMOVAL AND INSTALLATION
3
1
4
2
1. Front fog lamp switch
Fog lamp removal steps
2. Front bumper
3. Fog lamp bezel
4. Fog lamp assembly
INSPECTION
FOG LAMP SWITCH CONTINUITY CHECK
Switch position
Terminal No.
p
1
2
3
4
–
5
6
OFF
ON
CHASSIS ELECTRICAL –
Rear Combination Lamp
54-42
REAR COMBINATION LAMP
TROUBLESHOOTING
For the troubleshooting of the lighting monitor warning buzzer, refer to P.54-33.
REAR COMBINATION LAMP
REMOVAL AND INSTALLATION
Caution: SRS
Before removal of air bag module and clock spring, refer to GROUP 52B – SRS Service Precautions and Air Bag
Module and Clock Spring.
2
1
3
1. Column switch
Rear combination lamp removal
steps
2. Rear end trim
3. Rear combination lamp
INSPECTION
LIGHTING SWITCH CONTINUITY CHECK
Switch position
Terminal No.
Connector B
Connector A
5
6
7
1
LIGHTING
SWITCH
OFF
SWITCH
TAIL
HEAD
Connector A
Connector B
CHASSIS ELECTRICAL –
Side Turn-signal Lamp
54-43
SIDE TURN-SIGNAL LAMP
SPECIAL TOOL
Tool
Number
Name
Use
MB990784
Ornament remover
Removal of side turn-signal lamp
SIDE TURN-SIGNAL LAMP
REMOVAL
INSTALLATION
Fit the hook side rearward.
Fender panel
MB990784
Lock
MB990784
Lock
Fender
panel
Hook
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст