Mitsubishi Lancer Evolution VI. Manual — part 88
EXTERIOR –
Marks
51-8
MARKS
REMOVAL AND INSTALLATION
2
1
3
"
A
A
1. Three-diamond mark
"
A
A
2. EVOLUTION-VI mark
"
A
A
3. LANCER mark
INSTALLATION SERVICE POINT
"
A
A
MARK INSTALLATION
Mounting Positions
1.
Three-diamond mark
Center of vehicle
44 mm
EXTERIOR –
Marks
51-9
2.
EVOLUTION-VI mark
Application tape end
Align bottom edge of
application tape with
that of trunk lid.
Align right side edge of
application tape with
trunk lid opening line.
3.
LANCER mark
Trunk lid opening line
Rear bumper line
38 mm
18 mm
INSTALLATION
1.
Clean the mark installation surfaces on the body with
unleaded petrol.
2.
Peel off the backing paper from the reverse side of the
marks, and then attach the marks to the vehicle body
so that they fit properly into position.
Caution
(1) When attaching the marks, the surrounding
temperature should be 20 – 38
°
C and the air should
be completely free from dust.
(2) If the surrounding temperature is lower than 20
°
C,
the marks and the places on the body where the
marks are to be attached should be heated to
20 – 30
°
C.
(3) After sticking, press the marks strongly against
the body panels. Neglecting this could cause
peeled off marks.
NOTES
52B-1
SUPPLEMENTAL
RESTRAINT
SYSTEM (SRS)
CONTENTS
. . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . .
SRS AIR BAG CONTROL UNIT
(SRS-ECU)
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
AIR BAG MODULES AND CLOCK
SPRING
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
AIR BAG MODULE DISPOSAL
PROCEDURES
. . . . . . . . . . . . . . . . . . . . . . . .
Undeployed Air Bag Module Disposal
Procedures
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Deployed Air Bag Module Disposal
Procedures
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CAUTION
D
Carefully read and observe the information in the SERVICE PRECAUTIONS (P.52B-3.) prior to any service.
D
For information concerning troubleshooting or maintenance, always observe the procedures in the Troubleshooting
(P.52B-6.) section.
D
If any SRS components are removed or replaced in connection with any service procedures, be sure to follow the
procedures in the INDIVIDUAL COMPONENT SERVICE section (P.52B-22.) for the components involved.
D
If you have any questions about the SRS, please contact your local distributor.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст