Mitsubishi Outlander (2013+). Manual — part 712
ETACS
CHASSIS ELECTRICAL
54A-333
CONNECTOR: C-421
ACB05926AB
Terminal
No.
Terminal
code
Check item
Check condition
Normal
condition
1
−
−
−
−
2
W.HI
Windshield wiper (HI) output
When windshield wipers are
operating at high speed
System
voltage
3
TAR1
Position lamp (RH) output
With position lamp ON
System
voltage
4
− 5
−
−
−
−
6
STP
Stop lamp switch power supply
Stop lamp switch: ON
System
voltage
7
W.LO
Windshield wiper (LO) output
When windshield wipers are
operating at low speed
System
voltage
8
TAL1
Position lamp (LH) output
With position lamp ON
System
voltage
9
BLP1
Inhibitor switch (R) input
Selector lever: R and ignition
switch: ON
System
voltage
10
DEFR
Defogger output
Defogger switch: ON
1 V or less
CONNECTOR: C-422
ACB05924AB
3
+BP
Power supply (fusible link No. 1)
Ignition switch: ON
System
voltage
4
− 5
−
−
−
−
6
DEFO-1
&
DEFO-2
Defogger output
Defogger switch: ON
1 V or less
7
−
−
−
−
8
HOSW
Horn switch input
Horn switch: ON
1 V or less
9
ST
Ignition switch (START) input
Ignition switch: START
System
voltage
10
− 11
−
−
−
−
12
+B, PWM Power supply (fusible link No. 20)
Ignition switch: ON
System
voltage
13
ACC1
Power supply (fuse No. 22)
Ignition switch: ACC
System
voltage
Terminal
No.
Terminal
code
Check item
Check condition
Normal
condition
Terminal
No.
Terminal
code
Check item
Check condition
Normal
condition
1
SLSO
Shift lock solenoid
When all the following conditions
are met.
• Ignition switch: ON
• Brake pedal: depressed
System
voltage
ETACS
CHASSIS ELECTRICAL
54A-334
ON-VEHICLE SERVICE
CUSTOMISATION FUNCTION
M1545002501550
By operating the M.U.T.-III ETACS system, the fol-
lowing functions can be customised. The pro-
grammed information is held even when the battery
is disconnected.
Adjustment
item (M.U.T.-III
display)
Adjustment item
Adjusting content
(M.U.T.-III display)
Adjusting content
Turn power
source
Adjustment of
turn-signal lamp
operation condition
ACC or IG1
Operable with ACC or ON position
IG1
Operable with ON position (initial
condition)
Comfort flasher
With/without
comfort flasher
function
Disable
No function
Enable
With function (initial condition)
Hazard answer
back
Adjustment of the
number of keyless
hazard warning
lamp answer back
flashes
Lock:1, Unlock:2
LOCK: Flashes once, UNLOCK: Flashes
twice (initial condition)
Lock:1, Unlock:0
LOCK: Flashes once, UNLOCK: No flash
Lock:0, Unlock:2
LOCK: No flash, UNLOCK: Flash twice
Lock:2, Unlock:1
LOCK: Flash twice, UNLOCK: Flash once
Lock:2, Unlock:0
LOCK: Flash twice, UNLOCK: No flash
Lock:0, Unlock:1
LOCK: No flash, UNLOCK: Flash once
Lock:0, Unlock:0
No function
ETACS
CHASSIS ELECTRICAL
54A-335
Front wiper
operation
Adjustment of the
intermittent
windshield wiper
operation <vehicles
without lighting
control sensor>
Normal INT
Intermittent wiper interval is fixed to 4
seconds.
Variable INT
Intermittent wiper interval is calculated only
by the wiper volume control.
Speed Sensitive
Intermittent wiper interval is calculated
according to the intermittent wiper volume
control and vehicle speed (initial
condition).
Adjustment of the
intermittent
windshield wiper
operation <vehicles
with lighting control
sensor>
Normal INT
Intermittent wiper interval is fixed to 4
seconds.
Variable INT
Intermittent wiper interval is calculated only
by the wiper volume control.
Speed Sensitive
Intermittent wiper interval is calculated
according to the intermittent wiper volume
control and vehicle speed.
Rain Sensitive
Intermittent wiper interval is calculated
according to the intermittent wiper volume
control and lighting control sensor (initial
condition).
Front/rear wiper
washer
Disabling or
enabling
washer-linked wiper
function
Only Washer
No function
Washer & Wiper
With function: Without delayed finishing
wipe function <Initial condition>
With after wipe
With function: With delayed finishing wipe
function
Intermittent time
of rear wiper
Adjustment of rear
wiper interval
0 sec.
No wiper interval
4 sec.
4 seconds
8 sec.
8 seconds (initial condition)
16 sec.
16 seconds
Rear wiper Low
speed mode
Disabling or
enabling rear wiper
continuous
operation
Disable
No function
Enable
With function (initial condition)
Auto fold mirror
Electric folding door
mirror automatic
unfolding function
<vehicles with
electric retractable
remote controlled
door mirrors>
Not Auto
No synchronised operation
Open Vehicle SPD
Vehicle speed-dependent operation
Open/Close by IG
Ignition switch linked operation
OPN/CLS Keyless
Keyless entry linked operation (initial
condition)
Sensitivity for
auto lamp
Lighting control
sensor sensitivity
(illumination
intensity) <vehicles
with lighting control
sensor>
Level 1 bright
High ambient brightness
Level 2 bright
Standard ambient brightness (initial
condition)
Level 3
Low ambient brightness
Level 4 dark
Low-low ambient brightness
Adjustment
item (M.U.T.-III
display)
Adjustment item
Adjusting content
(M.U.T.-III display)
Adjusting content
ETACS
CHASSIS ELECTRICAL
54A-336
Room lamp
delay timer with
door
Adjustment of
interior lamp delay
shutdown time
0 sec.
0 second (no delay shutdown time)
7.5 sec.
7.5 seconds
15 sec.
15 seconds (initial condition)
30 sec.
30 seconds
60 sec.
60 seconds
120 sec.
120 seconds
180 sec.
180 seconds
Head lamp auto
cut customise
Adjustment of
headlamp
automatic shutdown
function
Disable
No function
Enable (B-spec.)
With function (initial condition)
Interior lamp
auto cut timer
Adjustment of
interior lamp
automatic shutdown
function operation
time
Disable
No function
3 min
3 minutes
30 min
30 minutes (initial condition)
60 min
60 minutes
Comfort flasher
switch time
Switch operation
time to activate the
comfort flasher
function
Normal
0.4 second (initial condition)
Long
0.8 second
Intelligent/Comf
ort washer
With/without
Comfort washer
function
Disable
No function (Initial condition)
Enable
With function
Auto door
unlock
Adjustment of the
auto door unlock
function
Disable
Without function (initial condition)
Always (P pos)
With function: Operates when the shift
lever or the selector lever is moved to the
P position.
Always(Lock pos)
With function: Operates when the ignition
switch is moved to the LOCK (OFF)
position.
Door unlock
mode
Adjustment of
power door locks
with selective
unlocking
All Doors Unlock
Without function: The first operation of
keyless entry system or unlock operation
by KOS unlocks all doors (initial condition).
Dr Door Unlock
With function: The first operation of
keyless entry system or unlock operation
by KOS unlocks the driver's door only, and
the second unlock operation within 2
seconds after that unlocks all doors.
Timer lock timer Timer lock period
adjustment
30 sec.
30 seconds (initial condition)
60 sec.
60 seconds
120 sec.
120 seconds
180 sec.
180 seconds
Adjustment
item (M.U.T.-III
display)
Adjustment item
Adjusting content
(M.U.T.-III display)
Adjusting content
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст