Mitsubishi Montero (1998+). Manual — part 266
(3) - Or inspect every year.
LUBRICATION SPECIFICATIONS
Material
Condition
Specification
Engine Oil
Ambient Temperature Less Than
SAE 5W-30
(1)
0 F (-18 C) To 100 F (38 C)
Ambient Temperature Above 0 F
SAE 10W-30
(-18 C) To Over 100 F (38 C)
Brake Fluid
All
DOT 3 Or DOT 4
(1) - SAE 5W-30 engine oil is preferred. SAE 10W-30 may be used if
the Ambient Temperature is above 0 F (-18 C).
FLUID CAPACITIES
Item
Condition
Specification (1)
Engine Oil
Oil Pan
4.5 Qts. (4.3L)
(1)
Oil Filter
0.32 Qts. (0.3L)
Oil Cooler
0.32 Qts. (0.3L)
(1) - Capacities are recommended or calculated levels. Always use
dipstick to measure level.
112,500 MILE (187,500 KM) NORMAL SERVICE
112,500 MILE (187,500 KM) NORMAL SERVICE
VERIFY
Last Major Service Was Performed
REPLACE
Engine Oil (1)
Engine Oil Filter (2)
(1) - Change once a year or every 7,500 miles (12,000 KM).
(2) - If mileage is less than 7,500 miles (12,000 KM) each year,
replace the oil filter at every oil change.
LUBRICATION SPECIFICATIONS
Material
Condition
Specification
Engine Oil
Ambient Temperature Less Than
SAE 5W-30
(1)
0 F (-18 C) To 100 F (38 C)
Ambient Temperature Above 0 F
SAE 10W-30
(-18 C) To Over 100 F (38 C)
(1) - SAE 5W-30 engine oil is preferred. SAE 10W-30 may be used if
the Ambient Temperature is above 0 F (-18 C).
FLUID CAPACITIES
Item
Condition
Specification (1)
Engine Oil
Oil Pan
4.5 Qts. (4.3L)
(1)
Oil Filter
0.32 Qts. (0.3L)
Oil Cooler
0.32 Qts. (0.3L)
(1) - Capacities are recommended or calculated levels. Always use
dipstick to measure level.
120,000 MILE (200,000 KM) NORMAL SERVICE
120,000 MILE (200,000 KM) NORMAL SERVICE
VERIFY
Last Major Service Was Performed
SERVICE
Ball Joints With Grease Nipple (6)
Propeller Shaft Joints (6)
INSPECT
Fuel Hoses (3)
Fuel System (Tank, Pipe Line, Connection & Fuel Tank Filler
Tube Cap) (3)
Evaporative Emission Control System (Except Evaporative
Emission Canister) (7)
Drive Belt (For Generator, Water Pump, Power Steering Pump)
Manual Transmission Oil
Transfer Oil
Disc Brake Pads (4)
Brake Hoses (4)
Ball Joint & Steering Linkage Seals (3)
Drive Shaft Boots (4)
Exhaust System (3)
Distributor Cap & Rotor (7)
REPLACE
Engine Oil (1)
Engine Oil Filter (2)
Engine Coolant
Automatic Transmission Fluid
Rear Axle Oil
Spark Plugs
Timing Belt (9)
Ignition Cables (8)
Air Cleaner Filter
(1) - Change once a year or every 7,500 miles (12,000 KM).
(2) - If mileage is less than 7,500 miles (12,000 KM) each year,
replace the oil filter at every oil change.
(3) - Or inspect every 2 years.
(4) - Or inspect every year.
(5) - Or change every 2 years.
(6) - Or lubricate grease every 2 years.
(7) - Or inspect every 5 years.
(8) - Or replace every 5 years.
(9) - For California & Massachusettes, this maintenance is
recommended but not required.
LUBRICATION SPECIFICATIONS
Material
Condition
Specification
Engine Oil
Ambient Temperature Less Than
SAE 5W-30
(1)
0 F (-18 C) To 100 F (38 C)
Ambient Temperature Above 0 F
SAE 10W-30
(-18 C) To Over 100 F (38 C)
Engine
All
50/50 Mixture Of
Coolant
Distilled Water &
Ethylene Glycol
Manual
All
API Classification GL-4
Transmission
SAE 75W-85W Or 75W-90
Automatic
All
"ATF DEXRON II" Or
Transmission
Equivalent
Brake Fluid
All
DOT 3 Or DOT 4
Rear Axle
All
API Classification GL-5
Or Higher (2)
Transfer Case
All
API Classification GL-4
SAE 75W-85W Or 75W-90
(1) - SAE 5W-30 engine oil is preferred. SAE 10W-30 may be used if
the Ambient Temperature is above 0 F (-18 C).
(2) - SAE90, 85W-90, 80W-90 may be used in temperatures above
-10 F (-23 C). SAE 80W, 80W-90 may be used in temperatures
from -30 F (-34 C) to -10 F (-23 C). SAE 75W may be used
in temperatures below -30 F (-34 C).
FLUID CAPACITIES
Item
Condition
Specification (1)
Engine Oil
Oil Pan
4.5 Qts. (4.3L)
(1)
Oil Filter
0.32 Qts. (0.3L)
Oil Cooler
0.32 Qts. (0.3L)
Engine
Drained; With Reserve Tank
10 Qts. (9.5L)
Coolant
Automatic
Drained
8.9 Qts. (8.5L)
Transmission
Manual
Drained
3.3 Qts. (3.2L)
Transmission
Rear Axle
Drained
3.3 Qts. (3.2L)
Transfer Case
Drained
2.6 Qts. (2.5L)
(1) - Capacities are recommended or calculated levels. Always use
dipstick to measure level.
LUBRICATION SPECIFICATIONS
LUBRICATION SPECIFICATIONS TABLE
Material
Condition
Specification
Engine Oil
Ambient Temperature Less Than
SAE 5W-30
(1)
0 F (-18 C) To 100 F (38 C)
Ambient Temperature Above 0 F
SAE 10W-30
(-18 C) To Over 100 F (38 C)
Power
All
Automatic Transmission
Steering
Fluid DEXRON II
Fluid
Engine
All
50/50 Mixture Of
Coolant
Distilled Water &
Ethylene Glycol
Transfer Case
All
API Classification GL-4
SAE 75W-85W Or 75W-90
Front Axle
All
API Classification GL-5
Or Higher (2)
Clutch Fluid
All
DOT 3 Or DOT 4
Hook Lock
All
Multipurpose Grease
Catch, Door
NLGI Grade 2
Lock Strikers
Seat Adjust-
ers, Backdoor
Lock, Parking
Brake Cable
Mechanism
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст