Mitsubishi Montero (1998+). Manual — part 25
Removal & Installation
1) Discharge A/C system, using approved refrigerant
recovery/recycling equipment. Remove glove box with lower frame
attached. Loosen duct joint bolt to free duct joint. Disconnect A/C
switch harness. Disconnect evaporator drain hose.
2) Disconnect refrigerant lines at firewall side of engine
compartment. Remove evaporator top bolts in passenger compartment.
Remove evaporator assembly. To install, reverse removal procedure. See
Figs. 12 and 13. If replacing evaporator, add 1.4 ounces of
refrigerant oil to new evaporator.
Fig. 12: Removing Evaporator Assembly
Courtesy of Mitsubishi Motor Sales of America.
Fig. 13: Exploded View Of Evaporator Assembly
Courtesy of Mitsubishi Motor Sales of America.
REFRIGERANT TEMPERATURE SENSOR
Removal & Installation
Discharge A/C system, using approved refrigerant
recovery/recycling equipment. Disconnect refrigerant temperature
sensor wiring connector. Remove temperature sensor from compressor. To
install, reverse removal procedure. Use new "O" ring on temperature
sensor.
TORQUE SPECIFICATIONS
TORQUE SPECIFICATIONS TABLE
Application Ft. Lbs. (N.m)
A/C Compressor Bolt/Nut . . . . . 17-20 (23-27)
A/C Compressor Bracket Bolt/Nut . . . . .. 37 (50)
A/C Compressor Clutch Coil Nut . . . . ... 12 (16)
A/C Engine Coolant Temperature Switch . . . 26 (35)
INCH Lbs. (N.m)
Blower Motor Bolts/Nuts . . . . . . ... 44 (5)
Condenser Bolts/Nuts . . . . . . . 106 (12)
Dual-Pressure Switch . . . . . . . . 89 (10)
Evaporator Assembly Bolts/Nuts . . . . . 44 (5)
Heater Assembly Bolts/Nuts . . . . . . 44 (5)
WIRING DIAGRAMS
Fig. 14: Manual A/C-Heater System Wiring Diagram
Courtesy of Mitsubishi Motor Sales of America.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст