Mitsubishi Montero Sport (2004+). Manual — part 383
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-35
CAUTION
Make sure thrust bearing number 12 is mounted in the cor-
rect direction.
6. Apply Vaseline or petroleum jelly on the thrust bearing
number 12, and then install on the front end of the output
shaft.
7. Install the underdrive clutch.
8. Apply Vaseline or petroleum jelly on the thrust bearing
number 11, and then install on the front end of the
underdrive clutch retainer.
AKX00063
THRUST BEARING NO.12
OUTPUT
SHAFT
AD
AKX00064
AKX00065
AKX00067
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-36
CAUTION
Make sure thrust bearing number 11 is mounted in the cor-
rect direction.
9. Install the underdrive clutch hub.
10.Apply Vaseline or petroleum jelly on the thrust bearing
number 10, and then install it on the underdrive clutch hub.
AKX00066
THRUST
BEARING NO.11
UNDERDRIVE
CLUTCH
RETAINER
AC
AKX00068
AKX00070
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-37
CAUTION
Make sure thrust bearing number 10 is mounted in the cor-
rect direction.
11.Install the output flange.
12.Apply Vaseline or petroleum jelly on the thrust bearing
number 9, and then install on the output flange.
AKX00069
THRUST
BEARING NO.10
UNDERDRIVE
CLUTCH HUB
AC
AKX00071
AKX00073
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-38
CAUTION
Make sure thrust bearing number 9 is mounted in the cor-
rect direction.
CAUTION
Measure and record the thickness of the thrust race num-
ber 8 to be assembled.
13.Apply Vaseline or blue petroleum jelly on the thrust race
number 8 being used, and then install it on the rear side of
the center support.
CAUTION
• Install the center support so that the oil holes shown in
the illustration face the lower side of the transmission
case.
• Make sure that the thrust race number 8 attached to the
rear side of the center support does not fall off.
14.Install the center support.
15.Remove the two output shaft support mounting bolts.
16.Using the two removed bolts, install special tool MB991603
to the specified torque.
Specified torque: 23
± 3 N⋅m (17 ± 2 ft-lb)
AKX00072
THRUST
BEARING NO.9
OUTPUT FLANGE
AC
AKX00074
THRUST RACE NO.8
AB
AKX00075
AKX00076
MB991603
AC
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст