Mitsubishi Montero Sport (2004+). Manual — part 450
DOOR
TSB Revision
BODY
42-55
NOTE: After inspecting intermediate connector C-39 inspect
the wire. If intermediate connector C-39 is damaged, repair or
replace it. Refer to GROUP 00E
, Harness Connector
Inspection. Then go to Step 15.
Q: Are there any damaged harness wires between
ETACS-ECU connector D-10 (terminal No.26) <Vehicles
without keyless entry system>, D-26 (terminal No.28)
<Vehicles with keyless entry system> or D-27 (terminal
No.52) <Vehicles with keyless entry system> and door
lock key cylinder switch (LH) connector F-06 (terminals
No.1 and No.3 <Vehicles with keyless entry system>)?
YES : Repair or replace the harness wire, then go to Step
15.
NO : Go to Step 14.
STEP 14. Check the harness wire between door lock key
cylinder switch connector F-06 and ground.
NOTE: After inspecting intermediate connector C-39 inspect
the wire. If intermediate connector C-39 is damaged, repair or
replace it. Refer to GROUP 00E
, Harness Connector
Inspection. Then go to Step 15.
Q: Is the harness wire between door lock key cylinder
switch connector F-06 and ground damaged?
YES : Repair or replace the harness wire, then go to Step
15.
NO : Replace the ETACS-ECU then go to Step 15.
STEP 15. Retest the system.
Q: Does the door lock function operate normally?
YES : The procedure is complete.
NO : Return to Step 1.
AC309309AJ
CONNECTOR: C-39
C-39
AC309370
2 1
3
CONNECTOR: F-06
F-06
COMPONENT SIDE
FRONT DOOR <LH>
AB
AC309309AJ
CONNECTOR: C-39
C-39
DOOR
TSB Revision
BODY
42-56
INSPECTION PROCEDURE 5: Some Doors do not Lock or Unlock.
AC004384
<Vehicles without keyless entry system>
AC
Door Lock Actuator Circuit
DOOR
TSB Revision
BODY
42-57
AC004328
<Vehicles with keyless entry system>
AC
AC309309AL
C-01
CONNECTORS: C-01, C-39
C-39
AC309353AB
C-12
CONNECTOR: C-12
DOOR
TSB Revision
BODY
42-58
.
COMMENT ON TROUBLE SYMPTOM
If a door or the liftgate can not be locked or unlocked
by the central door locking system, the door lock
actuator may be defective.
.
CIRCUIT OPERATION
When the door lock actuator receives the lock or
unlock signal from the ETACS-ECU, the actuator will
lock or unlock the door.
.
TECHNICAL DESCRIPTION (COMMENT)
The cause may be a malfunction of the door lock
actuator or of a wiring harness or connector.
.
TROUBLESHOOTING HINTS
• Malfunction of the door lock actuator
• Damaged wiring harness or connector
AC004311
D-27 (B)
D-10
JUNCTION BLOCK (REAR)
CONNECTORS: D-10, D-27
BA
AC004329AB
CONNECTORS: E-01, E-18, E-31, E-42
E-01
E-42
E-31
E-18
AC004332AC
CONNECTORS: F-21, F-24
<PASSENGER'S SIDE>
F-24 (B)
F-21
AC004331
CONNECTORS: F-09, F-12
<DRIVER'S SIDE>
F-12 (B)
F-09
AC
AC004330
CONNECTOR: G-04
AC
<LIFTGATE>
G-04
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст