Mitsubishi Montero (2002-2004). Manual — part 233
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54Ba-9
HOW TO CHECK ECUs
M1549014900208
1. Use the scan tool and the SWS monitor kit to
check ECUs. (Refer to MUT-II Reference Manual)
2. The following ECUs can be checked by using the
scan tool and the SWS monitor kit.
NOTE: The "ECU COMM CHK" function checks a
communication status of ECUs "NG" does not
always mean ECU malfunction. If a malfunction is
found by the "ECU COMM CHK," proceed "Symptom
Procedure" (Refer to
SWS monitor kit-compatible ECUs and their conditions
NOTE:
.
•
*
1
: If the ignition switch is turned to the "LOCK"
(OFF) or "ACC" when "NG" is displayed beside
the "ETACS ECU" or the signal request line is
abnormal, the scan tool shows "NG" beside the
"COLUMN ECU."
•
*
2
: When "NG" is displayed beside the "ETACS
ECU," the scan tool shows "NG" beside the
"FRONT ECU" and "SUNROOF ECU."
•
*
3
: If "NG" is displayed beside the "COLUMN
ECU," "NG" is displayed on the "CENTER DISP."
SERVICE DATA CHECK
M1549015000208
1. Use the scan tool and the SWS monitor kit to
check "Service Data."
This "Service Data" check is applicable for
signals, which are transmitted and received
through the SWS communication line. For input
signals, which are not compatible with the SWS
monitor kit, refer to the Pulse Check procedure
(by using the scan tool or voltmeter)
.
2. The following input signals can be checked by
using the scan tool and the SWS monitor kit.
NOTE: If a problem is found in the "Service Data"
check, refer to the Problems during Input Signal
Check <SWS monitor>. (Refer to
.)
<DATA LIST REFERENCE TABLE>
• COLUMN ECU (column switch)
ECUs TO BE CHECKED
DISPLAY ON SCAN
TOOL
NORMAL
CONDITION
ECU CONDITION
Column switch (column-
ECU)
COLUMN ECU
OK*
1
All of the column switch, power
supply, ground and interconnecting
communication line are normal
ETACS-ECU
ETACS ECU
OK
All of the ETACS-ECU switch, power
supply, ground and interconnecting
communication line are normal
Front-ECU
FRONT ECU
OK*
2
All of the front-ECU, power supply,
ground and interconnecting
communication line are normal
Sunroof motor assembly
(sunroof-ECU)
SUNROOF ECU
OK*
2
All of the sunroof motor assembly,
power supply, ground and
interconnecting communication line
are normal
RV meter
CENTER DISP.
OK*
3
All of the RV meter, power supply,
ground and interconnecting
communication line are normal
Other SWS-related ECUs
Other ECUs
NG
ECUs are not used
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54Ba-10
CHECK
ITEM
ITEM
NO.
DISPLAY ON
SCAN TOOL
CHECK CONDITION
NORMAL
CONDITION
Dimmer
switch
02
DIMMER SW
Dimmer switch: ON
ON
Dimmer switch: OFF
OFF
Windshield
washer
switch
09
FRONT
WASH.SW
Windshield washer switch: ON
ON
Windshield washer switch: OFF
OFF
Headlight
washer
switch
16
H/L WASHER
SW
Headlight washer switch: ON
ON
Headlight washer switch: OFF
OFF
Headlight
switch
00
HEADLIGHT
SW
Lighting switch: HEAD
ON
Lighting switch: Other than HEAD
OFF
Windshield
high-speed
wiper switch
07
HI WIPER SW
Wiper switch: HI
ON
Wiper switch: Other than HI
OFF
With or
without
windshield
intermittent
wiper interval
adjusting
knob
15
INT WIPE
KNOB
Vehicles with intermittent wiper adjusting
knob
EQUIP
Vehicles without intermittent wiper adjusting
knob
NON
Windshield
intermittent
wiper switch
05
INT WIPER SW Wiper switch: INT
ON
Wiper switch: Other than INT
OFF
Windshield
low-speed
wiper switch
06
LO WIPER SW Wiper switch: LO
ON
Wiper switch: Other than LO
OFF
Windshield
mist wiper
switch
08
MIST WIPER
SW
Wiper switch: Mist
ON
Wiper switch: Other than "Mist" position
OFF
Passing light
switch
03
PASSING SW
Passing light switch: ON
ON
Passing light switch: OFF
OFF
Tail light
switch
01
TAILLIGHT SW Lighting switch: TAIL
ON
Lighting switch: OFF
OFF
Turn-signal
light switch
(LH)
11
T/S LH SW
Turn-signal light switch: LH
ON
Turn-signal light switch: Other than LH
OFF
Turn-signal
light switch:
RH
10
T/S RH SW
Turn-signal light switch: RH
ON
Turn-signal light switch: Other than RH
OFF
Rear wiper
switch
13
REAR WIPER
SW
Rear wiper switch: INT
ON
Rear wiper switch: Other than INT
OFF
Rear washer
switch
14
REAR
WASH.SW
Rear wiper switch: Washer
ON
Rear wiper switch: Other than "Washer"
position
OFF
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54Ba-11
• ETACS ECU
CHECK
ITEM
ITEM
NO.
DISPLAY ON
SCAN TOOL
CHECK CONDITION
NORMAL
CONDITION
BEEP DATA 60
beep data
1. Ignition switch: ACC or ON
2. Carry out the audio preset operation.
ON (2 kHz) (only
momentarily when
switch is operated)
Other than the condition above
OFF
Tone alarm
43
BUZZER
1. Ignition switch: LOCK (OFF)
2. Key reminder switch: ON
3. Front door switch: ON (front door open)
ON
When requirements for sounding each
warning tone alarm are not satisfied
OFF
Front door
switch
32
FRONT DOOR
SW
Front door switch (right or left): right or left
door switch is on (right or left front door is
open)
ON
Front door switches (right and left): both
right and left door switches are off (both
right and left front doors are closed)
OFF
Center
display input
signal
62
DISPLAY
SIGNAL
1. Ignition switch: ACC or ON
2. Carry out the audio preset operation.
YES (only
momentarily when
switch is operated)
Other than the condition above
NO
Center
display sleep
status
61
DISPLAY
SLEEP
Ignition switch: LOCK (OFF)
SLEEPING
Ignition switch: ACC or ON
OPERATING
Front door
switch
32
FRONT DOOR
SW
Front door switch (right or left): right front
door or left front door switch is on (right or
left front door is open):
ON
Front door switch (right or left): Both right
and left door switches are off (both right and
left front doors are closed)
OFF
Front fog
lights
36
F.FOG LIGHT
1. Lighting switch: HEAD or TAIL
2. Fog light switch: ON
ON
Other than the condition above
OFF
Headlight
automatic
shutdown
function
35
H/L AUTO-CUT 1. Lighting switch: Other than OFF
2. Ignition switch: from ON or START to
LOCK (OFF) or ACC
3. Front door switch: ON (front door open)
OFF to ON (after
approximately one
second)
When requirements for the headlight
automatic shutdown are not satisfied
OFF
Ignition
switch (IG1)
30
IG SW (IG1)
Ignition switch: ON or START
ON
Ignition switch: LOCK (OFF) or ACC
OFF
Ignition
switch (ACC)
31
IG SW (ACC)
Ignition switch: ACC or ON
ON
Ignition switch: LOCK (OFF) or START
OFF
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54Ba-12
NOTE: For item number 43, the scan tool also dis-
play "ON" when the light reminder tone alarm or R
(reverse) position warning tone alarm is triggered.
• FRONT ECU
NOTE: For item number 70, the scan tool also dis-
plays "NG" under the "ECU COMM CHK" when it dis-
plays "NO ACK" under the front-ECU check.
• SUNROOF ECU (sunroof motor assembly)
NOTE: For item number 72, the scan tool also dis-
plays "NG" under the "ECU COMM CHK" when it dis-
plays "No response" under the sunroof-ECU check.
Transmission
range switch
("R" position)
41
INHIBITOR SW Transmission range switch: R position
ON
Transmission range switch: Other than R
position
OFF
Windshield
intermittent
wiper interval
37
INT WIPE
TIME
1. Ignition switch: ACC or ON
2. Operate the intermittent wiper adjusting
knob, and change the wiper interval
The scan tool
displays
intermittent wiper
interval in
response to the
intermittent wiper
adjusting knob
positions
Theft-alarm
headlights
45
THEFTALM. H/
L
Keyless entry transmitter panic button: ON
ON
Keyless entry transmitter panic button: OFF OFF
CHECK
ITEM
ITEM
NO.
DISPLAY ON
SCAN TOOL
CHECK CONDITION
NORMAL
CONDITION
CHECK
ITEM
ITEM
NO.
DISPLAY ON
SCAN TOOL
CHECK CONDITION
NORMAL
CONDITION
Response by
the front-
ECU
70
FRONT ECU
ACK
Lighting switch is at position other than OFF
(excluding when high-beam is on) or the
wiper switch is at position other than OFF
NORMAL ACK
• Ignition switch: ON or START
• Lighting switch: OFF
• Wiper switch: OFF
SLEEP ACK
• Lighting switch: HEAD
• Headlight: High-beam
HI-BEAM ACK
Except above conditions
NO ACK
CHECK
ITEM
ITEM
NO.
DISPLAY ON
SCAN TOOL
CHECK CONDITION
NORMAL
CONDITION
Response by
the sunroof-
ECU
72
S/R ECU ACK
1. Ignition switch: ON or START
2. While sunroof is off
NORMAL ACK
→
SLEEP ACK (after
approximately 30
seconds)
1. Ignition switch: ON or START
2. One of the sunroof switches is on
INPUT CHECK
→
NORMAL ACK
Except above conditions
NO ACK
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст