Mitsubishi Montero (2002-2004). Manual — part 289
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-203
General circuit diagram for the keyless entry system
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-204
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-205
INSPECTION PROCEDURE E-1: Keyless Entry System: Keyless entry system does not operate.
NOTE: This troubleshooting procedure requires the
use of scan tool MB991502 and SWS monitor kit
MB991862. For details on how to use the SWS mon-
itor, refer to "How to use SWS monitor"
.
CIRCUIT OPERATION
A receiver is incorporated in the ETACS-ECU. This
receiver receives a lock or unlock signal from the
transmitter.
.
TROUBLESHOOTING HINTS
• The transmitter may be defective
• The ETACS-ECU may be defective
Transmitter ("LOCK"/"UNLOCK") Input Signal
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-206
DIAGNOSIS
Required Special Tools:
• MB991223: Harness Set
• MB991502: Scan Tool (MUT-II)
• MB991862: SWS Monitor Kit
STEP 1. Use scan tool MB991502 to select "ECU COMM
CHK" on the SWS monitor display.
Check the ETACS-ECU.
CAUTION
To prevent damage to scan tool MB991502, always turn the
ignition switch to the "LOCK" (OFF) position before con-
necting or disconnecting scan tool MB991502.
(1) Connect scan tool MB991502 to the data link connector
(16-pin).
(2) Connect SWS monitor kit MB991862 to the data link
connector (13-pin).
(3) Turn the ignition switch to the "LOCK" (OFF) position.
(4) Operate scan tool MB991502 according to the procedure
below to display "ECU COMM CHK."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "SWS MONITOR."
4. Select "ECU COMM CHK."
(5) Scan tool MB991502 should show "OK" on the "ECU
COMM CHK" menu for the "ETACS ECU" menu.
Q: Is "OK" displayed on the "ETACS ECU" menu?
YES : Go to Step 2.
NO : Refer to Inspection Procedure A-3 "Communication
with ETACS-ECU is not possible
STEP 2. Check the input signal (by using the pulse check
mode of the monitor.)
Check the input signals from the transmitter.
(1) Connect scan tool MB991502 to the data link connector
(16-pin).
(2) Operate scan tool MB991502 as follows:
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "PULSE CHECK."
(3) Push the transmitter "LOCK" or "UNLOCK" switch.
(4) Check that scan tool MB991502 sounds.
Q: When the transmitter "LOCK" or "UNLOCK" switch is
pushed, does scan tool MB991502 sound?
YES : Replace the ETACS-ECU. Verify that all the doors
can be locked or unlocked by using the transmitter.
NO : Refer to Inspection Procedure P-10 "The ETACS-
ECU does not receive a signal from the lock, unlock
switch or panic switch
AC204222AB
16-pin
13-pin
MB991502
MB991862
AC204222AB
16-pin
13-pin
MB991502
MB991862
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст