Mitsubishi Pajero Pinin. Manual — part 285
BODY –
Door
42-16
REAR DOOR HANDLE AND LATCH
REMOVAL AND INSTALLATION
Pre-removal Operation
Door Trim Removal (Refer to P.42-9.)
Post-installation Operation
Door Inside Handle Play Check
Door Outside Handle Play Check
Door Trim Installation (Refer to P.42-9.)
6 Nm
4
3
2
1
Door handle and door latch
assembly removal steps
B
1. Door inside handle
Waterproof film (Refer to P.42-9.)
2. Door outside handle
3. Door latch assembly
Door check removal steps
Waterproof film (Refer to P.42-9.)
A
4. Door check
INSTALLATION SERVICE POINTS
A
DOOR CHECK INSTALLATION
Install with the following identification marks upward.
Items
Identification mark
Left door
26L
Right door
26R
Identification mark
BODY –
Door
42-17
B
DOOR INSIDE HANDLE INSTALLATION
1.
Install the inside lock cable to the door inside handle as
follows:
(1) Install the inner cable end in the inside lock cable
to the clip in the door inside handle.
(2) Turn the inside lock knob to the door lock position.
(3) Install the outer cable end to the door inside handle
securely.
(4) Install the clip to the inner cable.
2.
Install the inside handle rod to the door inside handle.
3.
Install the door inside handle to the door.
INSPECTION
DOOR LOCK ACTUATOR CHECK
Rod position
Terminal No.
Rod operation
2
3
LOCK
LOCK to UNLOCK
UNLOCK
UNLOCK to LOCK
Outer
cable end
Inner cable
Clip
Door inside handle
Inside handle rod
<Left side>
View A
Unlock
<Right side>
View B
Unlock
Lock
A
B
Lock
BODY –
Door
42-18
WINDOW GLASS RUNCHANNEL AND DOOR OPENING
WHETHERSTRIP
REMOVAL AND INSTALLATION
<FRONT DOOR>
Sectional view of
clip position
Sectional view of
clip position
5
4
3
2
1
Door inner opening weatherstrip
removal steps
Scuff plate (Refer to GROUP 52A.)
Cowl side trim (Refer to GROUP 52A.)
Center pillar lower trim (Refer to
GROUP 52A.)
1. Door inner opening weatherstrip
Door outer opening weatherstrip
removal
A
2. Door outer opening weatherstrip
Door window glass runchannel
removal steps
3. Door window glass runchannel
4. Door window glass lower
runchannel
Door beltline moulding removal
steps
Outside rear view mirror
5. Door beltline moulding
BODY –
Door
42-19
<REAR DOOR>
Sectional view of
clip position
Sectional view of
clip position
5
4
3
2
1
A
1. Door outer opening weatherstrip
Door window glass runchannel
removal steps
2. Door window glass runchannel
Door lower sash (Refer to P.42-13.)
3. Door window glass lower
runchannel
Door beltline inner weatherstrip
removal steps
Door trim (Refer to P.42-9.)
4. Door beltline inner weatherstrip
Door beltline moulding removal
5. Door beltline moulding
REMOVAL SERVICE POINT
A
DOOR OUTER OPENING WEATHERSTRIP
REMOVAL
Make a tool as shown and remove the door opening
weatherstrip
.
15 mm
4 mm
8 mm
Thickness
1mm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст