Mitsubishi Pajero Pinin. Manual — part 222
WHEEL AND TYRE –
Troubleshooting
31-3
TROUBLESHOOTING
Symptom
Probable cause
Remedy
Reference page
Rapid wear at
shoulders
Under-inflation
or lack of rotation
Adjust the tyre
pressure.
31-4.
Rapid wear at
centre
Over-inflation or
lack of rotation
Cracked treads
Under-inflation
Adjust the tyre
pressure.
31-4.
Wear on one
side
Excessive cam-
ber
Inspect the cam-
ber.
Refer to GROUP
33A – On-vehicle
Service.
Feathered edge
Incorrect toe-in
Adjust the toe-in.
Bald spots
Unbalanced
wheel
Adjust the imbal-
anced wheels.
–
Scalloped wear
Lack of rotation of tyres or worn or
out-of-alignment suspension
Rotate the tyres
and check the
front suspension
alignment.
Refer to GROUP
33A – On-vehicle
Service.
WHEEL AND TYRE –
On-vehicle Service/Wheel and Tyre
Spare tyre
Spare tyre
cover
31-4
ON-VEHICLE SERVICE
TYRE INFLATION PRESSURE CHECK
NOTE
For information on tyre inflation pressure, refer to the label
attached near the driver’s side door striker.
TYRE WEAR CHECK
Measure the tread depth of tyres.
Limit: 1.6 mm
If the remaining tread depth is less than the limit, replace
the tyre.
NOTE
When the tread depth of tyres is reduced to 1.6 mm or less,
wear indicators will appear.
WHEEL RUNOUT CHECK
Jack up the vehicle so that the wheels are clear of the floor.
While slowly turning the wheel, measure wheel runout with
a dial indicator.
Limit:
Item
Steel wheel
Aluminium wheel
Radial runout mm
1.2
1.0
Lateral runout mm
1.2
1.0
If wheel runout exceeds the limit, replace the wheel.
WHEEL AND TYRE
INSTALLATION SERVICE POINT
Tighten the wheel nut to the specified torque.
Tightening torque: 98 Nm
When installing the spare tyre and spare tyre cover to the
spare tyre carrier, tighten the wheel nut, lock cylinder and
bolt to the specified torque.
Tightening torque: 46 Nm
Radial
Lateral
WHEEL AND TYRE – General/General Information
31-1
GROUP 31
WHEEL AND TYRE
GENERAL
OUTLINE OF CHANGE
A newly designed aluminium wheel has been added. Its appearance has been improved by attaching
a balance weight on the rim inside surface.
Adhesive type balance weight
GENERAL INFORMATION
SPECIFICATIONS
Items
Specification
Wheel
Type
Aluminium type*
Size
16
6J
Amount of wheel offset mm
46
Pitch circle diameter (P.C.D.) mm
114.3
NOTE
*: Optional items
POWER PLANT
MOUNT
Click on the applicable bookmark to selected the required model year
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст