Mitsubishi Pajero Pinin. Manual — part 33
ENGINE LUBRICATION –
On-vehicle Service
12-6
4.
Install the oil pressure gauge.
NOTE
Use a adapter of PT 1/8 thread.
5.
Run the engine to warm it.
6.
After the engine has been warmed up, check that oil
pressure is within the standard value.
Standard value:
At idle: 29 kPa or more
At 3,500 r/min: 294 – 686 kPa
7.
Remove the oil pressure gauge.
8.
Apply the specified sealant to the thread of oil pressure
switch.
Specified sealant: 3M ATD Part No. 8660 or equivalent
9.
Use the special tool to tighten the oil pressure switch
to the specified torque.
Tightening torque: 19 Nm
Caution
Do not start the engine within one hour after the oil
pressure switch has been installed.
10. Install the oil pressure switch terminal.
MD998054
ENGINE LUBRICATION –
General/On-vehicle Service
12-1
GROUP 12
ENGINE LUBRICATION
GENERAL
OUTLINE OF CHANGE
A quality of the engine oil has been changed.
ON-VEHICLE SERVICE
Specified Engine Oil (ACEA and API classification):
ACEA A1, A2, A3/API SG or higher
NOTES
GASOLINE DIRECT
INJECTION (GDI)
Click on the applicable bookmark to selected the required model year
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст