Mitsubishi Pajero Pinin. Manual — part 263
STEERING –
Steering Wheel and Shaft
37A-13
REMOVAL SERVICE POINTS
A
A
"
STEERING WHEEL REMOVAL
MB990803
STEERING –
Steering Wheel and Shaft
37A-14
DISASSEMBLY AND REASSEMBLY
BW0581AL
1
4
3
2
AW1122AL
<L.H. drive vehicles>
<R.H. drive vehicles>
5
17 Nm
1
2
3
5
Disassembly steps
A
A
" "
A
A
1. Special bolt
"
A
A
2. Steering lock bracket
"
A
A
3. Steering lock cylinder assembly
4. Shaft assembly
<L.H. drive vehicles>
5. Steering column shaft assembly
DISASSEMBLY SERVICE POINT
A
A
"
SPECIAL BOLT REMOVAL
1.
In the special bolt, drill a hole deep enough for the tap
to stand.
2.
Using a left-hand tap, remove the special bolt.
REASSEMBLY SERVICE POINT
"
A
A
STEERING LOCK CYLINDER ASSEMBLY/
STEERING LOCK BRACKET/SPECIAL BOLT
INSTALLATION
1.
When installing the steering lock cylinder assembly and
steering lock bracket to the steering column assembly,
temporarily install the steering lock in alignment with the
column boss.
2.
Check that the steering lock works properly. Then, tighten
the special bolts until the heads twists off.
Steering
lock bracket
Steering lock body
Special bolt
Left-hand tap
STEERING –
Power Steering Gear Box and Linkage
37A-15
POWER STEERING GEAR BOX AND LINKAGE
REMOVAL AND INSTALLATION
Caution: SRS
On vehicles with SRS, before removing steering gear box, refer to GROUP 52B. Also, put the front
wheels in straight–ahead position and remove the ignition key. Failure to do so may damage the
SRS clock spring and render the SRS air bag inoperative, which results serious driver injury.
Pre-removal Operation
D
Power Steering Fluid Draining (Refer to P.37A-9.)
D
Under Cover Removal
Post-installation Operation
D
Check the Dust Cover for Cracks or Damage by
Pushing it with Finger.
D
Under Cover Installation
D
Power Steering Fluid Supplying and bleeding
(Refer to P.37A-9.)
D
Checking Steering Wheel Position with Wheels
Straight Ahead
D
Front Wheel Alignment Check and Adjustment
(Refer to GROUP 33A – On-vehicle Service.)
2
13
18 Nm
12 Nm
70 Nm
2
3
5
1
34 Nm
15 – 33 Nm
11
8
10
15 Nm
4
6
<L.H. drive vehicles>
12
9
STEERING –
Power Steering Gear Box and Linkage
37A-16
15 – 33 Nm
2
13
18 Nm
12 Nm
70 Nm
7
5
2
3
5
1
34 Nm
12 Nm
8
11
9
10
15 Nm
4
6
<R.H. drive vehicles>
12
Removal steps
1. Steering gear and joint connecting bolt
2. Splash shield
3. Split pin
A
A
"
4. Tie rod end and knuckle
connection
"
B
A
5. Return hose
"
A
A
6. Pressure hose
7. Nut <R.H drive vehicles>
8. Pressure tube
9. Return tube
10. O-ring
11. Cylinder clamp
12. Gear housing clamp
A
B
"
13. Steering and gear linkage
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст