Mitsubishi Pajero Pinin. Manual — part 62
GDI –
Throttle Body
13A-114
THROTTLE BODY
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
D
Engine Coolant Draining and Supplying (Refer to
GROUP 14 – On-vehicle Service.)
D
Resonance Tank Removal and Installation (Refer
to GROUP 15.)
1
2
3
4
5
19 Nm
3
Removal steps
1. Throttle position sensor connector
connection
2. Throttle control servo connector con-
nection
3. Water hose connection
"
A
A
4. Throttle body assembly
5. Throttle body gasket
INSTALLATION SERVICE POINT
"
A
A
THROTTLE BODY INSTALLATION
If the throttle body is replaced, initialize the electronic-controlled
throttle valve system.
Initialization
Turn on the ignition switch, and turn it to LOCK (OFF) position
within one second. Then leave it for at least ten seconds
with the ignition switch in LOCK (OFF) position.
GDI –
Throttle Body
13A-115
DISASSEMBLY AND REASSEMBLY
1
2
Disassembly steps
"
A
A
1. Throttle position sensor
2. Throttle body
REASSEMBLY SERVICE POINTS
"
A
A
THROTTLE POSITION SENSOR
1.
Position the throttle position sensor on the throttle body
along the dotted line as shown in the illustration.
2.
Rotate the throttle position sensor anticlockwise as shown
in the illustration, and then tighten the screws.
3.
Measure resistance value between terminal Nos. 1(sensor
power supply) and 2 (throttle position sensor 1st-channel
output) as well as 1 (sensor power supply) and 4 (throttle
position sensor 2nd-channel output).
Normal condition
Open the throttle valve slowly
from the idle position to
full-open position.
Resistance value changes
smoothly in response to
throttle valve opening angle.
4.
If the resistance value does not change smoothly, replace
the throttle position sensor.
Sensor power
supply
Earth
Throttle posi-
tion sensor
(2nd channel)
output
Throttle position sensor
(1st channel) output
GDI –
Injector Driver
13A-116
INJECTOR DRIVER
REMOVAL AND INSTALLATION
5 Nm
1
2
5 Nm
Removal steps
A
A
"
1. Injector driver
2. Bracket
REMOVAL SERVICE POINT
A
A
"
INJECTOR DRIVER REMOVAL
Press the injector driver connector in the place shown in the
illustration to disconnect the injector driver connector.
Caution
1.
Disconnect the battery (–) cable from its terminal
before carrying out this operation.
2.
High-tension current is flowing in the harness between
the injector driver and the injector while engine is
running, and the injector driver will become hot after
the vehicle has been driven, so take care when
handling it.
Lock
GDI –
Throttle Valve Controller
13A-117
THROTTLE VALVE CONTROLLER
INSTALLATION SERVICE POINT
If the throttle valve controller is replaced, initialize the
electronic-controlled throttle valve system.
Initialization
Turn on the ignition switch, and turn it to LOCK (OFF) position
within one second. Then leave it for at least ten seconds
with the ignition switch in LOCK (OFF) position.
Throttle valve controller
Accelerator cable
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст