Mitsubishi Eclipse. Manual — part 798
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-201
STEP 15. Check harness for short circuit to ground
between transmission range switch connector B-41
terminal 4 and combination meter connector C-43 terminal
9. <Vehicles with sport mode>
Q: Is the harness wire in good condition?
YES : Go to Step 27.
NO : Repair or replace the harness wire.
STEP 16. Measure the transmission range switch output
voltage at PCM connector C-61 <2.4L Engine> or C-63
<3.0L Engine> by backprobing. ("D" position)
Measure the voltage between terminal 102 and ground by
backprobing.
• When selector lever position is "P," voltage should measure
0.5 volt or less.
• When selector lever position is "R," voltage should measure
0.5 volt or less.
• When selector lever position is "N," voltage should measure
0.5 volt or less.
• When selector lever position is "D," voltage should measure
battery positive voltage.
• When selector lever position is "3," voltage should measure
0.5 volt or less. <Vehicles without sport mode>
• When selector lever position is "2," voltage should measure
0.5 volt or less. <Vehicles without sport mode>
• When selector lever position is "L," voltage should measure
0.5 volt or less. <Vehicles without sport mode>
• When selector lever position is sport mode, voltage should
measure battery positive voltage. <Vehicles with sport
mode>
Q: Is the measured voltage within the specified range?
YES : Go to Step 21.
NO : Turn the ignition switch to the "LOCK" (OFF) position.
Then go to Step 17.
AC001844
CONNECTOR: B-41
DIPSTICK
AK
B-41
AC001729AW
CONNECTOR: C-43
C-43
AC001906 AN
C-61 <2.4L ENGINE> OR
C-63 <3.0L ENGINE>
HARNESS CONNECTOR:
HARNESS SIDE
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-202
STEP 17. Check harness for open circuit or short circuit to
ground between transmission range switch connector
B-41 terminal 1 and PCM connector C-61 <2.4L Engine> or
C-63 <3.0L Engine> terminal 102.
Q: Is the harness wire in good condition?
YES <Vehicles without sport mode> : Go to Step 27.
YES <Vehicles with sport mode> : Go to Step 18.
NO : Repair or replace the harness wire.
AC001844
CONNECTOR: B-41
DIPSTICK
AK
B-41
AC001657
CONNECTOR: C-61 <2.4L ENGINE> OR
C-63 <3.0L ENGINE>
PCM
BC
C-61 <2.4L ENGINE> OR C-63 <3.0L ENGINE>
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-203
STEP 18. Check shift switch assembly connector C-65,
intermediate connector C-27 and combination meter
connector C-41 for loose, corroded or damaged terminals,
or terminals pushed back in the connector. <Vehicles with
sport mode>
Q: Are the connectors and terminals in good condition?
YES : Go to Step 19.
NO : Repair or replace the damaged components. Refer to
GROUP 00E, Harness Connector Inspection
AC001741
CONNECTOR: C-65
AS
C-65
AC001741
CONNECTOR: C-27
AR
C-27
AC001729AX
CONNECTOR: C-41
C-41
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-204
STEP 19. Check harness for short circuit to ground
between transmission range switch connector B-41
terminal 1 and shift switch assembly connector C-65
terminal 1.
Q: Is the harness wire in good condition?
YES : Go to Step 20.
NO : Repair or replace the harness wire.
STEP 20. Check harness for short circuit to ground
between shift switch assembly connector C-65 terminal 2
and combination meter connector C-41 terminal 50.
<Vehicles with sport mode>
Q: Is the harness wire in good condition?
YES : Go to Step 27.
NO : Repair or replace the harness wire.
AC001844
CONNECTOR: B-41
DIPSTICK
AK
B-41
AC001741
CONNECTOR: C-65
AS
C-65
AC001741
CONNECTOR: C-65
AS
C-65
AC001729AX
CONNECTOR: C-41
C-41
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст