Mitsubishi Eclipse. Manual — part 342
![](/vehicles/winoney/grold/thow/maqu.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <2.4L>
13A-861
STEP 8. Measure the power supply voltage at fuel pump
relay 2 harness side connector C-105.
(1) Disconnect the connector C-105 and measure at the
harness side.
(2) Turn the ignition switch to the "ON" position.
(3) Measure the voltage between terminal No. 3 and ground.
• Voltage should be battery positive voltage.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is battery positive voltage (approximately 12 volts)
present?
YES : Go to Step 9.
NO : Check harness connector C-111 at intermediate
connector for damage, and repair or replace as
required. Refer to, GROUP 00E, Harness Connector
Inspection
. If intermediate connector is in
good condition, repair harness wire between ignition
switch connector C-87 (terminal No. 2) and fuel pump
relay 2 connector C-105 (terminal No. 3) because of
open circuit. Then confirm that the malfunction
symptom is eliminated.
STEP 9. Check connector D-17 at fuel pump for damage.
Q: Is the connector in good condition?
YES : Go to Step 10.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then confirm that the
malfunction symptom is eliminated.
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
AK300746
CONNECTOR: C-105
AB
C-105
AK101347
1
2
3
4
C-105 HARNESS
CONNECTOR:
COMPONENT SIDE
AY
AK300453
1
2
3
4
5
D-17 (GR)
AB
CONNECTOR: D-17
HARNESS CONNECTOR:
COMPONENT SIDE
![](/vehicles/winoney/grold/thow/jutenthel.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <2.4L>
13A-862
STEP 10. Check the fuel pump operation.
(1) Disconnect fuel pump connector D-17.
(2) Use jumper wires to connect fuel pump connector terminal
No. 5 to the positive battery terminal and terminal No. 4 to
the negative battery terminal.
• An operating sound of the fuel pump should be heard.
Q: Is the fuel pump operating properly?
YES : Go to Step 11.
NO : Replace the fuel pump. Then confirm that the
malfunction symptom is eliminated.
STEP 11. Check the continuity at fuel pump harness side
connector D-17.
(1) Disconnect the connector D-17 and measure at the harness
side.
(2) Check for the continuity between terminal No. 4 and
ground.
• Should be less than 2 ohms.
Q: Is the continuity normal?
YES : Go to Step 12.
NO : Repair harness wire damage between fuel pump
connector D-17 (terminal No. 4) and ground because
of open circuit or harness damage. Then confirm that
the malfunction symptom is eliminated.
AK300453
1
2
3
4
5
D-17 (GR)
AB
CONNECTOR: D-17
HARNESS CONNECTOR:
COMPONENT SIDE
AKX01439
FUEL PUMP SIDE
CONNECTOR
AB
1 2 3
4 5
AK300453
1
2
3
4
5
D-17 (GR)
AB
CONNECTOR: D-17
HARNESS CONNECTOR:
COMPONENT SIDE
AKX01440AK
1
2
3
4
5
D-17 HARNESS CONNECTOR:
COMPONENT SIDE
![](/vehicles/winoney/grold/thow/xiayooung.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <2.4L>
13A-863
STEP 12. Check for open circuit and short circuit to
ground and harness damage between fuel pump relay 2
connector C-105 (terminal No. 4) and fuel pump connector
D-17 (terminal No. 5).
NOTE: Check harness after checking intermediate connector
C-101. If intermediate connectors are damaged, repair or
replace them. After to GROUP 00E, Harness Connector
Inspection
. Then check that the malfunction is elimi-
nated.
Q: Is the harness wire in good condition?
YES : Go to Step 13.
NO : Repair it. Then confirm that the malfunction symptom
is eliminated.
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
AK300746
CONNECTOR: C-105
AB
C-105
AK300453
1
2
3
4
5
D-17 (GR)
AB
CONNECTOR: D-17
HARNESS CONNECTOR:
COMPONENT SIDE
![](/vehicles/winoney/grold/thow/ceve.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <2.4L>
13A-864
STEP 13. Check connector C-49 at ECM <M/T> or
connector C-50 at PCM <A/T> for damage.
Q: Is the connector in good condition?
YES : Go to Step 14.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then confirm that the
malfunction symptom is eliminated.
AK300413
1
14
4
19
5
22
6
17
8
15
9
18
7
20
16
2
21
23
26
24
25
3
10
11
12
13
CONNECTOR: C-49 <M/T>
C-49 (G)
AB
HARNESS CONNECTOR:
COMPONENT SIDE
AK300414
2
3
4
5
6
7
8
9
11
12
13
14
15
16
17
18
19
20
30
21
22
23
24
25
26
27
28
29
31
32
33
34
35
1
10
C-50 (GR)
CONNECTOR: C-50 <A/T>
AB
HARNESS CONNECTOR:
COMPONENT SIDE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст