Mitsubishi Eclipse. Manual — part 967
SUNROOF ASSEMBLY
TSB Revision
BODY
42-93
08
Fully closed (tilt
down)
Ignition switch: ON
1. Sunroof switch: TILT UP
2. Sunroof switch: OPEN, CLOSE (Each
direction switch of the sunroof switch is
pushed while the sunroof is conducting the
automatic tilt up operation.)
The sunroof will continue
automatic operation until
tilted up.
09
Fully closed or while
opening
Ignition switch: ON
• Sunroof switch: OPEN
Block the sunroof before the sunroof is fully
open.
The sunroof stop.
10
Fully opened or
while closing
Ignition switch: ON
• Sunroof switch: CLOSE
Block the sunroof before the sunroof is fully
closed.
The sunroof moves back
toward open and stops.
11
Fully opened or
while opening
Ignition switch: ON
1. Sunroof switch: CLOSE
Block the sunroof before the sunroof is fully
closed.
2. Sunroof switch: TILT UP, OPEN or CLOSE
The sunroof moves back
toward open and stops
when any switch is pushed.
12
Fully closed
Ignition switch: ON
1. Ignition switch: LOCK (OFF)
2. Sunroof switch: OPEN [Within 30 seconds
after the ignition switch is turned LOCK
(OFF).]
The sunroof automatic
opens 30 seconds after the
ignition switch is turned
LOCK (OFF).
13
Fully opened or
while closing
Ignition switch: ON
1. Sunroof switch: CLOSE
2. Ignition switch: LOCK (OFF)
3. Sunroof switch: TILT UP, OPEN or CLOSE
[Within 30 seconds after the ignition switch is
turned LOCK (OFF).]
The sunroof closes while the
sunroof switch is pushed to
the CLOSE position. Then,
the sunroof does not move
when any switch is pushed.
14
Fully closed (tilt
down)
Ignition switch: ON
1. Sunroof switch: TILT UP
2. Ignition switch: LOCK (OFF) [The ignition
switch is turned LOCK (OFF) while the
sunroof switch is automatically opening.]
The sunroof automatic
opens only 30 seconds after
the ignition switch is turned
LOCK (OFF).
15
Fully opened or
while closing
Ignition switch: ON
1. Sunroof switch: CLOSE
2. Ignition switch: LOCK (OFF) [The ignition
switch is turned LOCK (OFF) while the
sunroof switch is pushed to the CLOSE
position.]
The sunroof closes while the
sunroof switch is pushed to
the CLOSE position.
NO. SUNROOF INITIAL
POSITION
SWITCH OPERATION
JUDGMENT (NORMAL)
SUNROOF ASSEMBLY
TSB Revision
BODY
42-94
16
Fully closed
Ignition switch: ON
1. Ignition switch: LOCK (OFF)
2. Sunroof switch: OPEN [Within 30 seconds
after the ignition switch is turned LOCK
(OFF).]
3. Door switch: ON [Within 30 seconds after the
ignition switch is turned LOCK (OFF).]
The sunroof automatic
opens and stops when the
door switch is LOCK (OFF).
17
Fully closed
Ignition switch: ON
1. Ignition switch: LOCK (OFF)
2. Sunroof switch: OPEN [Within 30 seconds
after the ignition switch is turned LOCK
(OFF).]
3. Door switch: ON [Within 30 seconds after the
ignition switch is turned LOCK (OFF).]
The sunroof closes while the
sunroof switch is pushed to
the CLOSE position. Then,
the sunroof does not move
when the door switch is ON.
18
Fully closed (tilt
down)
Ignition switch: ON
1. Ignition switch: LOCK (OFF)
2. Sunroof switch: TILT UP [Within 30 seconds
after the ignition switch is turned LOCK
(OFF).]
3. Door switch: ON [Within 30 seconds after the
ignition switch is turned LOCK (OFF).]
The sunroof automatic
opens and stops when the
door switch is ON.
NO. SUNROOF INITIAL
POSITION
SWITCH OPERATION
JUDGMENT (NORMAL)
SUNROOF ASSEMBLY
TSB Revision
BODY
42-95
SUNROOF ASSEMBLY
REMOVAL AND INSTALLATION
M1426001200319
Post-installation Operation <Roof lid glass assembly,
Sunroof assembly>
• Sunroof Fit Adjustment (Refer to
• Sunroof Water Test (Refer to
AC004739 AB
1
2
3
4
5
6
5.4 ± 1.5 N·m
48 ± 13 in-lb
5
1. ROOF LID GLASS ASSEMBLY
SUNROOF SWITCH REMOVAL
STEPS
2. SUNROOF SWITCH COVER
• HEADLINING (REFER TO GROUP
52A
.)
3. SUNROOF SWITCH
SUNROOF MOTOR REMOVAL
STEPS
• HEADLINING (REFER TO GROUP
52A
.)
<<A>> >>B<<
4. SUNROOF MOTOR ASSEMBLY
DRAIN HOSE REMOVAL STEPS
• FRONT SIDE AIR DAM (FRONT
DRAIN HOSE) (REFER TO
.)
• HEADLINING (REFER TO GROUP
52A
.)
• SPLASH SHIELD (FRONT DRAIN
HOSE) (REFER TO
.)
<<B>> >>A<<
5. DRAIN HOSE
SUNROOF ASSEMBLY REMOVAL
STEPS
2. SUNROOF SWITCH COVER
• HEADLINING (REFER TO GROUP
52A
.)
<<A>> >>B<<
4. SUNROOF MOTOR ASSEMBLY
5. DRAIN HOSE CONNECTION
6. SUNROOF ASSEMBLY
SUNROOF ASSEMBLY
TSB Revision
BODY
42-96
REMOVAL SERVICE POINTS
.
<<A>> SUNROOF MOTOR REMOVAL
CAUTION
Always close the roof lid glass fully before removing the
sunroof motor. If the fully-closed positions of the roof lid
glass and the sunroof motor are not the same, the sunroof
will not operate properly.
NOTE: If there is a problem with the sunroof motor so that the
roof lid glass cannot close fully, use an Allen wrench to turn the
gear section of the sunroof motor to fully close the roof lid
glass.
.
<<B>> DRAIN HOSE REMOVAL
Tie a cord to the end of the drain hose, and wind tape around
the tie until it is smooth. Then pull the drain hose out into the
wheel housing.
INSTALLATION SERVICE POINTS
.
>>A<< DRAIN HOSE INSTALLATION
1. Tie the cord that was used during removal to the end of the
drain hose, and wind tape around it until it is smooth.
2. Pull the cord to pull through the drain hose.
3. Install the grommet, and then position the drain hose so that
it protrudes from the grommet as shown in the illustration.
.
AC000513AB
CORD
DRAIN HOSE
AC000514
CORD
DRAIN HOSE
AB
AC002392
GROMMET
25 mm (1.0 in)
(FRONT SIDE, REAR SIDE RH)
25 ± 3 mm (1.0 ± 0.1 in)
(REAR SIDE LH)
AB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст