Mitsubishi Eclipse. Manual — part 963
TRUNK LID
TSB Revision
BODY
42-77
TRUNK LID
REMOVAL AND INSTALLATION
M1421002200210
CAUTION
1. Never try to disassemble trunk lid gas spring.
2. Always bore a hole in the gas spring to release the interior gas before the spring is discarded.
3. Keep the trunk lid gas spring away from fire or flame.
AC102186
6
9
1
3
10 8
2
7
2
5
4
13 ± 2 N·m
109 ± 21 in-lb
22 ± 4 N·m
16 ± 3 ft-lb
13 ± 2 N·m
109 ± 21 in-lb
22 ± 4 N·m
16 ± 3 ft-lb
12 ± 2 N·m
104 ± 21 in-lb
1
ADJUSTMENT
OF BUMPER
10
9
ADJUSTMENT OF CLEARANCE
AROUND TRUNK LID
5
ADJUSTMENT OF CLEARANCE
AROUND TRUNK LID
5
AB
REMOVAL STEPS
>>C<<
1. BUMPER
2. BUMPER
3. TRUNK LID STRIKER
>>B<<
4. TRUNK LID OPENING
WEATHERSTRIP
TRUNK LID LATCH REMOVAL
STEPS
• REAR END TRIM (REFER TO
GROUP 52A
.)
5. TRUNK LID LATCH
TRUNK LID GAS SPRING
REMOVAL STEPS
>>B<<
4. TRUNK LID OPENING
WEATHERSTRIP
TRUNK LID
TSB Revision
BODY
42-78
REMOVAL SERVICE POINT
.
<<A>> HARNESS CONNECTOR REMOVAL
Removal the grommet Tie a cord to the end of the harness con-
nector, wind plastic tape around it so that there is no other side.
INSTALLATION SERVICE POINTS
.
>>A<< HARNESS CONNECTOR INSTALLATION
1. Tie the cord that was used during removal to the end of the
harness connector, wind plastic tape around it so that there
is no unevenness.
2. Pull the cord to pull through the harness connector.
3. Install the grommet.
.
>>B<< TRUNK LID OPENING WEATHERSTRIP
INSTALLATION
Install the trunk lid opening weatherstrip so that its marking is
positioned at the center of the vehicle.
.
8. TRUNK LID GAS SPRING
TRUNK LID REMOVAL STEPS
6. HIGH MOUNTED STOPLIGHT
<<A>> >>A<<
7. HARNESS CONNECTOR
8. TRUNK LID HINGE
9. TRUNK LID
10. TRUNK LID HINGE
TRUNK LID GAS SPRING
REMOVAL STEPS (Continued)
AC003334AB
CORD
AC003335AB
CORD
CORD
AC003336
MARKING
AB
TRUNK LID
TSB Revision
BODY
42-79
>>C<< BUMPER INSTALLATION
Install the bumper as shown in figure. Be sure they are
adjusted so the trunk lid is even with the rear fenders and body
on all sides.
AC003337AB
TRUNK LID
BUMPER
20 mm (0.79 in)
TRUNK LID
TSB Revision
BODY
42-80
TRUNK LID LOCK RELEASE HANDLE AND CABLE
REMOVAL AND INSTALLATION
M1421004500068
AC106507
1
2
3
4
22 ± 4 N·m
16 ± 3 ft-lb
5
6
7
4
7
7
REAR END TRIM
ADJUSTMENT OF TRUNK LID STEP
AND TRUNK LID STRIKER LINKAGE
AC
8
9
10
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст