Mitsubishi Galant. Manual — part 563
DOOR
TSB Revision
BODY
42-35
STEP 5. Check the harness wires between power window
main switch connector E-16 and rear power window sub-
switch <RH> connector E-09.
Q: Are there any damaged wires between power window
main switch connector E-16 and rear power window
sub-switch <RH> connector E-09?
YES : Repair them, then go to Step 6.
NO : Go to Step 6.
AC000570
CONNECTOR: E-16
AC
AC000576
CONNECTOR: E-09
AE
DOOR
TSB Revision
BODY
42-36
NOTE: After inspecting intermediate connector C-68, C-70 or
D-07, inspect the wire. If intermediate connector C-68, C-70 or
D-07 is damaged, repair or replace it. Refer to GROUP 00E
, Harness Connector Inspection. Then go to Step 6.
STEP 6. Check symptoms
Q: Does the rear door window <RH> open and close
normally?
YES : This diagnosis is complete.
NO : Return to Step 1.
AC003079AG
CONNECTOR
BLOCK (LH)
CONNECTOR: C-68
AC000564
CONNECTOR: C-70
CONNECTOR BLOCK (RH)
AB
AC000581AC
CONNECTOR: D-07
DOOR
TSB Revision
BODY
42-37
INSPECTION PROCEDURE 5: Some door windows do not open or close using the power window sub
switch (on passenger's door). (However, they open or close when the power window main switch is
used.)
AC000584AB
Power Window Sub Switch Power Supply
AC000561
CONNECTORS: C-66, C-67
C-66
C-67
AB
CONNECTOR
BLOCK (LH)
AC000568
C-70
C-72
CONNECTOR BLOCK (RH)
CONNECTORS: C-70, C-72
AB
DOOR
TSB Revision
BODY
42-38
CIRCUIT OPERATION
•
Power is supplied to the power window sub-
switch from the power window relay.
TECHNICAL DESCRIPTION (COMMENT)
•
The cause may be a malfunction of the power
window sub-switch power supply circuit.
TROUBLESHOOTING HINTS
•
Malfunction of the front power window sub-switch
<RH>
•
Malfunction of the rear power window sub-switch
<LH>
•
Malfunction of the rear power window sub-switch
<RH>
•
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tool:
•
MB991223: Harness Set
STEP 1. Check the power window sub-switch continuity.
(1) Remove the power window sub-switch. (Refer to
(2) Check the continuity when the power window sub-switch is
turned to the UP position or DOWN position.
Q: Is the power window sub-switch damaged?
YES : Replace it, then go to Step 3.
NO : Go to Step 2.
AC000581
CONNECTOR: D-19
AB
AC000570
E-12
CONNECTOR: E-12
AG
AC000576
CONNECTORS: E-05, E-09
AF
E-09
E-05
SWITCH
POSITION
TESTER
CONNECTION
SPECIFIED
CONDITION
UP
4
−
5, 6
−
7
Continuity
OFF
4
−
5, 6
−
8
Continuity
DOWN
6
−
8, 4
−
7
Continuity
AC000585
1
2 3
4 5 6 7 8
<FRONT>
<REAR>
AB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст