Mitsubishi Galant. Manual — part 646
RADIO WITH TAPE PLAYER AND CD PLAYER
TSB Revision
CHASSIS ELECTRICAL
54A-137
STEP 4. Check that proper performance is
obtained when the vehicle is moved.
Q: Is proper performance obtained when the vehicle
is moved?
YES :
The auto-select function should operate
normally.
NO :
Go to Step 5.
STEP 5. Check that the antenna plug is
connected to the radio properly.
Q: Is the antenna plug connected to the radio
properly?
YES :
Go to Step 6.
NO :
The antenna plug is reconnected to the
radio properly. The auto-select function
should operate normally.
STEP 6. Check that the problem disappears when
another radio is used.
Q: Does the problem disappear if another radio is
used?
YES :
Repair or replace the radio. The auto-select
function should operate normally.
Inspection Procedure 19: Preset station are erased.
AC003979AB
Memory Backup Power Supply Circuit
TSB Revision
CHASSIS ELECTRICAL
RADIO WITH TAPE PLAYER AND CD PLAYER
54A-138
CIRCUIT OPERATION
The power is constantly supplied to the radio, tape
player, CD player and CD auto changer.
TECHNICAL DESCRIPTION (COMMENT)
The cause is probably a faulty radio, tape player, CD
player and CD auto changer memory backup power
supply circuit system.
TROUBLESHOOTING HINTS
•
Damaged harness wire or connector.
•
Malfunction of the radio, tape player, CD player
and CD auto changer.
DIAGNOSIS
Required Special Tool:
•
MB991223: Harness set
STEP 1. Check the radio, tape player, CD player and CD
auto changer memory backup power supply circuit by
back probing.
(1) Do not disconnect radio, tape player, CD player and CD
auto changer connector C-31.
(2) Measure the voltage between terminal number 11 and
ground by backprobing.
Q: Is the voltage approximately 12 volts (battery positive
voltage)?
YES : Repair or replace the radio, tape player, CD player
and CD auto changer. Check that a memory is
retained.
NO : Go to Step 2 .
AC003089
CONNECTOR: C-31
AT
AC003079 AB
CONNECTOR
BLOCK (LH)
CONNECTOR: C-66
AC003082AY
CONNECTOR: C-74
JUNCTION BLOCK
(FRONT VIEW)
AC003080 AB
JUNCTION BLOCK
(REAR VIEW)
CONNECTOR: C-84
1
2
3
4
5
6
7
8
9
10
11
12
13
14
ACX01870AC
CONNECTOR C-31
(HARNESS SIDE)
RADIO WITH TAPE PLAYER AND CD PLAYER
TSB Revision
CHASSIS ELECTRICAL
54A-139
STEP 2. Check harness connector C-31 at the radio, tape
player, CD player and CD auto changer for damage.
Q: Is harness connector C-31 in good condition?
YES : Go to Step 3 .
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Check that a memory
is retained.
AC003089
CONNECTOR: C-31
AT
TSB Revision
CHASSIS ELECTRICAL
RADIO WITH TAPE PLAYER AND CD PLAYER
54A-140
STEP 3. Check the harness wires between radio, tape
player, CD player connector C-31and battery.
NOTE: After inspecting intermediate connector C-66 and
junction block connectors C-74 and C-84, inspect the wire. If
intermediate connector C-66 and junction block connectors C-
74 and C-84 are damaged, repair or replace them. Refer to
GROUP 00E, Harness Connector Inspection
.
Q: Are the harness wires between the connector C-31 and
battery in good condition?
YES : Repair them. Check that a memory is retained.
NO : Repair or replace the radio, tape player, CD player.
Check that a memory is retained.
AC003089
CONNECTOR: C-31
AT
AC003079 AB
CONNECTOR
BLOCK (LH)
CONNECTOR: C-66
AC003082AY
CONNECTOR: C-74
JUNCTION BLOCK
(FRONT VIEW)
AC003080 AB
JUNCTION BLOCK
(REAR VIEW)
CONNECTOR: C-84
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст