Mitsubishi Eclipse / Eclipse Spyder (2000-2002). Service and repair manual — part 507
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-320
TCC SOL
DUTY
36
Torque converter
clutch solenoid valve
duty %
Warming up
Selector lever
position: 3
<Vehicles without
sport mode> or
Sport mode
<Vehicles with
sport mode>
Driving at speed of
50 km/h (31 mph)
in 3rd gear
Driving at constant
speed of 50 km/h (31
mph)
70
−
90 %
Release accelerator
pedal (at less than
50 km/h (31 mph))
70
−
90 %
→
0 %
Decreases
gradually as the
vehicle speed
decreases
TP SENSOR
11
Throttle position
sensor
Ignition switch: ON
Engine: Stopped
Selector lever
position: P
Accelerator pedal:
Fully closed
535
−
735 mV
Accelerator pedal:
Depressed
Gradually rises
from the above
value
Accelerator pedal:
Fully open
4,500
−
5,500
mV
U/D SOL
DUTY
32
Underdrive solenoid
valve duty %
Selector lever
position: L, 2, 3, D
<Vehicles without
sport mode> or
Sport mode
<Vehicles with
sport mode>
Driving at constant
speed of 10 km/h
(6.2 mph) in 1st gear
0 %
Driving at constant
speed of 30 km/h (19
mph) in 2nd gear
0 %
Driving at constant
speed of 50 km/h (31
mph) in 3rd gear
0 %
Driving at constant
speed of 50 km/h (31
mph) in 4th gear
100 %
VSS
29
Vehicle speed sensor
Selector lever
position: 3
<Vehicles without
sport mode> or
Sport mode
<Vehicles with
sport mode>
Idling with 1st gear
(Vehicle stopped)
0 km/h (0 mph)
Driving at constant
speed of 50 km/h (31
mph)
50 km/h (31
mph)
MUT-II SCAN
TOOL
DISPLAY
ITEM
NO.
INSPECTION ITEM
INSPECTION REQUIREMENT
NORMAL
CONDITION
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-321
ACTUATOR TEST REFERENCE TABLE
M1231008200044
MUT-II SCAN
TOOL
DISPLAY
ITEM
NO.
INSPECTION ITEM
TEST CONTENT
INSPECTION
REQUIREMENT
NORMAL
CONDITION
1st SHIFT
LMP
07
1st indicator light
<Vehicles with sport
mode>
Illuminate each
indicator light for
three to the signal
from the MUT-II.
•
Ignition switch:
ON
•
Selector lever
position: P
•
Engine:
stopped
•
Throttle
opening
voltage: Less
than one volts
Shift indicator light
illuminates.
2nd SHIFT
LMP
08
2nd indicator light
<Vehicles with sport
mode>
2ND SOL
03
Second solenoid valve
Drive the solenoid
valve specified by
the scan tool
(MUT-II) at 50 %
duty for five
seconds. No other
solenoid valve
should be
energized.
The solenoid
should click when
activated
3rd SHIFT
LMP
09
3rd indicator light
<Vehicles with sport
mode>
Illuminate each
indicator light for
three to the signal
from the MUT-II.
Shift indicator light
illuminates.
4th SHIFT
LMP
10
4th indicator light
<Vehicles with sport
mode>
A/T RELAY
12
A/T control relay
Control relay is
OFF for three
seconds.
Data list No. 54
•
(1) During test:
0 V
•
(2) Normal:
Battery positive
voltage [12 V]
L/R SOL
01
Low-reverse solenoid
valve
Drive the solenoid
valve specified by
the scan tool
(MUT-II) at 50 %
duty for five
seconds. No other
solenoid valve
should be
energized.
The solenoid
should click when
activated
O/D SOL
04
Overdrive solenoid
valve
TCC SOL
06
Torque converter clutch
solenoid valve
U/D SOL
02
Underdrive solenoid
valve
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-322
INVECS-II CANCEL COMMAND
M1231009500048
PCM TERMINAL VOLTAGE REFERENCE CHART FOR TRANSAXLE OPERATION
M1231008400048
MUT-II
SCAN
TOOL
DISPLAY
ITEM
NO.
ITEM
CONTENT
REMARKS
Std.
SHIFT
PATN
14
Standard
shift pat-
tern
Stops the INVECS-II
control and shifts gears
according to the stan-
dard shift pattern.
Use this function when performing procedure 8 in
the road tests. (Refer to
If the ignition switch is turned from "LOCK" (OFF)
to "ON," this function restores the INVECS-II con-
trol.
ACX01182 AB
TERMINAL
NO.
INSPECTION ITEMS
INSPECTION REQUIREMENT
NORMAL CONDITION
45
Crankshaft position sensor Engine: Cranking
0.4
−
4.0 V
Engine: Idling
1.5
−
2.5 V
46
Throttle position sensor
supplied voltage
Ignition switch: ON
4.8
−
5.2 V
50
A/T control relay
Ignition switch: LOCK (OFF)
0 V
Ignition switch: ON
10
−
12 V
57
Throttle position sensor
ground
Always
0.5 V or less
75
Auto-cruise signal
Ignition switch: ON
Battery positive voltage
76
Ground
Always
1 V or less
77
Solenoid valve power
supply
Ignition switch: LOCK (OFF)
0 V
Ignition switch: ON
Battery positive voltage
78
Throttle position sensor
Ignition switch: ON (check for
smooth voltage increase as
throttle is moved from idle
position to wide open throttle
Idle
0.6
−
0.8 V
Wide open
throttle
4.5
−
5.5 V
88
Ground
Always
0 V
89
Solenoid valve power
supply
Ignition switch: LOCK (OFF)
0 V
Ignition switch: ON
Battery positive voltage
97
Ground
Always
0 V
101
Park/Neutral position
switch: P
•
Ignition switch: LOCK (OFF)
•
Selector lever position: P
0 V
•
Ignition switch: LOCK (OFF)
•
Selector lever position: Other than above
Battery positive voltage
102
Park/Neutral position
switch: D
•
Ignition switch: LOCK (OFF)
•
Selector lever position: D
0 V
•
Ignition switch: LOCK (OFF)
•
Selector lever position: Other than above
Battery positive voltage
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-323
103
Input shaft speed sensor
•
Measure between terminals 57 and 103
with an oscilloscope.
•
Engine: 2,000 r/min
•
Selector lever position: 3 (3rd gear)
<Vehicles without sport mode>, Sport
mode (3rd gear) <Vehicle with sport mode>
Refer to
Inspection Procedure Using
an Oscilloscope.
104
Output shaft speed sensor
•
Measure between terminals 57 and 104
with an oscilloscope.
•
Engine: 2,000 r/min
•
Selector lever position: 3 (3rd gear)
<Vehicles without sport mode>, Sport
mode (3rd gear) <Vehicle with sport mode>
Refer to
Inspection Procedure Using
an Oscilloscope.
105
Shift indicator light: 1st
<Vehicles with sport
mode>
•
Engine: Idling
•
Gear range: 1st gear
Battery positive voltage
•
Engine: Idling
•
Gear range: other than 1st gear
0
−
0.9 V
106
Second solenoid valve
•
Engine: Idling
•
Selector lever position: 2 (2nd gear)
<Vehicles without sport mode>, Sport
mode (2nd gear) <Vehicles with sport
mode>
Battery positive voltage
•
Engine: Idling
•
Selector lever position: P
7
−
9 V
107
Torque converter clutch
solenoid valve
•
Engine: Idling
•
Selector lever position: L (1st gear)
<Vehicles without sport mode>, Sport
mode (1st gear) <Vehicles with sport
mode>
Battery positive voltage
108
Park/Neutral position
switch: R
•
Ignition switch: ON
•
Selector lever position: R
0 V
•
Ignition switch: ON
•
Selector lever position: Other than above
Battery positive voltage
109
Park/Neutral position
switch: 3 <Vehicles without
sport mode>
•
Ignition switch: ON
•
Selector lever position: 3
0 V
•
Ignition switch: ON
•
Selector lever position: Other than above
Battery positive voltage
Select switch <Vehicles
with sport mode>
•
Ignition switch: ON
•
Selector lever position: Sport mode
0 V
•
Ignition switch: ON
•
Selector lever position: Other than above
Battery positive voltage
110
Park/Neutral position
switch: L <Vehicles without
sport mode>
•
Ignition switch: ON
•
Selector lever operation: L
0 V
•
Ignition switch: ON
•
Selector lever operation: Other than above
Battery positive voltage
Select switch (Down)
<Vehicles with sport
mode>
•
Ignition switch: ON
•
Selector lever operation: Downshift and
hold the selector lever
0 V
•
Ignition switch: ON
•
Selector lever operation: Other than above
Battery positive voltage
TERMINAL
NO.
INSPECTION ITEMS
INSPECTION REQUIREMENT
NORMAL CONDITION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст