Mitsubishi Eclipse / Eclipse Spyder (2000-2002). Service and repair manual — part 451
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-95
STEP 10. Check harness for short circuit to ground
between crankshaft position sensor connector B-20
terminal 2 and PCM connector C-54 <2.4L Engine> or C-55
<3.0L Engine> terminal 45.
Q: Is the harness wire in good condition?
YES : Go to Step 4.
NO : Repair it.
AC004926AB
CONNECTOR: B-20
<2.4L ENGINE>
AC004927AB
CONNECTOR: B-20
<3.0L ENGINE>
AC001657
CONNECTOR: C-54 <2.4L ENGINE> OR
C-55 <3.0L ENGINE>
PCM
AL
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-96
STEP 11. Check the power supply voltage at crankshaft
position sensor connector B-20.
(1) Disconnect connector B-20 and measure at the harness
side.
(2) Turn the ignition switch to "ON" position.
(3) Measure the voltage between terminal 3 and ground.
•
Voltage should be battery positive voltage.
(4) Turn the ignition switch to "LOCK" (OFF) position.
Q: Is the voltage normal?
YES : Go to Step 13.
NO : Go to Step 12.
STEP 12. Check connector A-21X at MFI relay for damage.
Q: Is the connector in good condition?
YES : Repair it because of harness open circuit or short
circuit to ground between MFI relay connector A-21X
terminal 1 and crankshaft position sensor connector
B-20 terminal 3.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
.
AC004926AB
CONNECTOR: B-20
<2.4L ENGINE>
AC004927AB
CONNECTOR: B-20
<3.0L ENGINE>
ACX02112
HARNESS
CONNECTOR: B-20
AC
AC004306AB
BATTERY
CONNECTOR: A-21X
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-97
STEP 13. Check the continuity at crankshaft position
sensor connector B-20.
(1) Disconnect connector B-20 and measure at the harness
side.
(2) Check for the continuity between terminal 1 and ground.
•
Should be less than 2 ohm.
Q: Is the continuity normal?
YES : Go to Step 14.
NO : Repair it because of harness open circuit or damage
between crankshaft position sensor connector B-20
terminal 1 and ground.
AC004926AB
CONNECTOR: B-20
<2.4L ENGINE>
AC004927AB
CONNECTOR: B-20
<3.0L ENGINE>
ACX02113
HARNESS
CONNECTOR: B-20
AC
AUTOMATIC TRANSAXLE DIAGNOSIS
TSB Revision
AUTOMATIC TRANSAXLE
23A-98
STEP 14. Check connectors C-54 <2.4L Engine> or C-55
<3.0L Engine> at PCM and A-21X at the MFI relay for
damage.
Q: Are the harness connectors in good condition?
YES : Go to Step 15.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
.
AC001657
CONNECTOR: C-54 <2.4L ENGINE> OR
C-55 <3.0L ENGINE>
PCM
AL
AC004306AB
BATTERY
CONNECTOR: A-21X
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст