Mitsubishi Galant (2004+). Manual — part 1440
54A-3
HIGH-MOUNTED STOPLIGHT
REMOVAL AND INSTALLATION .
RHEOSTAT . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION .
INSPECTION . . . . . . . . . . . . . . . . .
HAZARD WARNING LIGHT
SWITCH . . . . . . . . . . . . . . . . . .
HAZARD WARNING LIGHT
DIAGNOSIS . . . . . . . . . . . . . . . . . .
HAZARD WARNING LIGHT
SWITCH . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . . .
INSPECTION . . . . . . . . . . . . . . . . . . . . .
COLUMN SWITCH. . . . . . . . . .
REMOVAL AND INSTALLATION .
HORN . . . . . . . . . . . . . . . . . . . .
DIAGNOSIS
<VEHICLE WITH KEYLESS ENTRY
SYSTEM>. . . . . . . . . . . . . . . . . . . .
HORN . . . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . . .
INSPECTION . . . . . . . . . . . . . . . . . . . . .
ACCESSORY SOCKET. . . . . .
REMOVAL AND INSTALLATION .
RADIO WITH CD PLAYER . . .
GENERAL DESCRIPTION . . . . . . .
RADIO WITH CD PLAYER, SPEAKER
AND ANTENNA DIAGNOSIS. . . . .
INTRODUCTION TO AUDIO SYSTEM
DIAGNOSIS . . . . . . . . . . . . . . . . . . . . . .
AUDIO SYSTEM DIAGNOSTIC
TROUBLESHOOTING STRATEGY . . . .
TROUBLE SYMPTOM CHART . . . . . . .
SYMPTOM PROCEDURES . . . . . . . . . .
ON-VEHICLE SERVICE . . . . . . . . .
SPEAKER TEST
(Vehicles with seven speakers) . . . . . . .
SPECIAL TOOL . . . . . . . . . . . . . . .
RADIO WITH TAPE PLAYER AND CD
PLAYER . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION. . . . . .
REMOTE CONTROLLED RADIO
SWITCH . . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION. . . . . .
INSPECTION . . . . . . . . . . . . . . . . . . . . .
SPEAKER . . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION. . . . . .
AMPLIFIER . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION. . . . . .
ANTENNA. . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION. . . . . .
54A-4
DEFOGGER . . . . . . . . . . . . . . .
GENERAL DESCRIPTION . . . . . .
DEFOGGER DIAGNOSIS . . . . . . .
ON-VEHICLE SERVICE. . . . . . . . .
PRINTED-HEATER LINES CHECK . . .
REAR WINDOW DEFOGGER SWITCH
REMOVAL AND INSTALLATION . . . . .
INSPECTION . . . . . . . . . . . . . . . . . . . . .
MULTI-CENTER DISPLAY . . .
GENERAL DESCRIPTION . . . . . .
DIAGNOSIS FUNCTION . . . . . . . .
DIAGNOSTIC TROUBLE CODE
CHART . . . . . . . . . . . . . . . . . . . . . .
DIAGNOSTIC TROUBLE CODE
PROCEDURES . . . . . . . . . . . . . . .
DIAGNOSIS . . . . . . . . . . . . . . . . . .
SYMPTOM PROCEDURES . . . . . . . . .
ON-VEHICLE SERVICE. . . . . . . . .
AMBIENT AIR TEMPERATURE UNIT
CUSTOMIZATION
(MIDDLE GRADE TYPE) . . . . . . . . . . . .
COMPASS CALIBRATION
(MIDDLE GRADE TYPE) . . . . . . . . . . . .
VEHICLE MAGNETIC
COMPENSATION . . . . . . . . . . . . . . . . .
CHECK AT MULTI CENTER DISPLAY
UNIT TERMINAL . . . . . . . . . . . . . . . . . .
SPECIAL TOOLS . . . . . . . . . . . . . .
MULTI-CENTER DISPLAY. . . . . . .
REMOVAL AND INSTALLATION. . . . . .
AMBIENT TEMPERATURE
SENSOR. . . . . . . . . . . . . . . . . .
INSPECTION . . . . . . . . . . . . . . . . .
PANIC ALARM. . . . . . . . . . . . .
REMOVAL AND INSTALLATION .
SPECIFICATIONS . . . . . . . . . .
FASTENER TIGHTENING
SPECIFICATIONS . . . . . . . . . . . . .
SERVICE SPECIFICATIONS . . . . .
BATTERY
TSB Revision
CHASSIS ELECTRICAL
54A-5
BATTERY
ON-VEHICLE SERVICE
BATTERY CHECK
M1541001000450
WARNING
Battery posts, terminals and related accessories con-
tain lead and lead compounds. WASH HANDS AFTER
HANDLING.
BATTERY VISUAL INSPECTION (1)
1. Ensure that the battery electrolyte level is between A and B
shown in the figure. Add if the level is lower than the
specified range.
2. Use a hydrometer and temperature gauge to check the
specific gravity of the electrolyte.
Standard value:
1.220
− 1.290 [ at 20°C (68°F)]
The specific gravity of electrolyte depends on its temperature.
Use the formula below to determine the proper value.
Conversion on centigrade
D
20
=(t
− 20) x 0.0007 + Dt
Conversion on Fahrenheit
D
20
=(t
− 68) x 0.0007 + Dt
D
20
: Specific gravity as if electrolyte temperature is 20
°C
(68
°F)
D
t
: Measured specific gravity
t : Measured temperature
BATTERY VISUAL INSPECTION (2)
Make sure the ignition switch is in "LOCK" (OFF) position and
all battery feed accessories are OFF.
1. Disconnect the negative cable from the battery before
disconnecting the positive cable.
WARNING
Care should be taken in the event the battery case is
cracked or leaking to protect hands from the electro-
lyte. A suitable pair of rubber gloves (not the house-
hold type) should be worn when removing battery by
hand.
2. Remove the battery from the vehicle.
3. Inspect battery carrier for damage caused by loss of acid
from the battery. If acid damage is present, it is necessary to
clean area with a solution of clean warm water and baking
soda. Scrub area with a stiff bristle brush. Wipe clean with a
cloth moistened with ammonia or baking soda in water.
4. Clean the battery, especially the top with same solutions as
described in step 3.
AC208957
A
B
AB
HYDROMETER
TEMPERATURE
GAUGE
A: 27(1.1)
B: 35(1.4)
mm (in)
BATTERY
TSB Revision
CHASSIS ELECTRICAL
54A-6
5. Inspect the battery case and cover for cracks. If cracks are
present, battery must be replaced.
6. Clean the battery post with a suitable battery post cleaning
tool.
7. Clean the inside surfaces of the terminal clamps with a
suitable battery terminal cleaning tool. Replace damaged or
frayed cables and broken terminal clamps.
8. Install the battery in the vehicle.
9. Connect the positive and negative cables to the battery in
the order of mention.
10.Tighten the clamp nut securely.
BATTERY CHARGING
M1541001100521
WARNING
When batteries are being charged, an explosive gas forms beneath the cover of each cell. Do
not smoke near batteries on charge or which have recently been charged. Do not break live
circuits at the terminals of the batteries on charge. A spark will occur where the live circuit is
broken. Keep all open flames away from the battery.
Battery electrolyte temperature may temporarily be
allowed to rise to 55
°C (131°F). Increase of electro-
lyte temperature above 55
°C (131°F) is harmful to
the battery, causing deformation of battery cell,
decrease in life of battery, etc.
CHARGE RATE
If the test indicator is white, the battery should be charged as outlined below. When the dot appears or when
maximum charge shown below is reached, charging should be stopped.
.
Charge Rate Chart
BATTERY
BCI Group size 86
BCI Group size 24
Slow charging
5 amps 10 hours
5 amps 11.2 hours
10 amps 5 hours
10 amps 5.6 hours
Fast charging
20 amps 2.5 hours
20 amps 2.8 hours
30 amps 1.67 hours
30 amps 1.87 hours
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст