Mitsubishi Galant (2004+). Manual — part 1533
GENERAL DESCRIPTION
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-25
NOTE: The illustration above shows the front impact sensor (LH) and the side impact sensor (LH). The posi-
tion of the front impact sensor (RH) and the side impact sensor (RH) is symmetrical to this.
AC306318
AC307339
AC305362
AC305028
DATA LINK CONNECTOR
SRS-ECU
SRS-ECU
AB
SERVICE PRECAUTIONS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-26
SERVICE PRECAUTIONS
M1524000300499
DANGER
•
In order to avoid injury to yourself or others from
accidental deployment of the air bag during servic-
ing, read and carefully follow all the precautions
and procedures described in this manual.
•
After disconnecting the battery cable, wait 60 sec-
onds or more before proceeding with the following
work. The SRS system is designed to retain
enough voltage to deploy the air bag for a short
time even after the battery has been disconnected,
so serious injury may result from unintended air
bag deployment if work is done on the SRS system
immediately after the battery cables are discon-
nected.
WARNING
•
Battery posts, terminals and related accessories
contain lead and lead compounds. WASH HANDS
AFTER HANDLING.
•
Do not use any electrical test equipment on or near
the SRS components, except those specified on
•
Never Attempt to Repair the Following Compo-
nents: SRS-ECU, Clock Spring, Air Bag Module,
Front impact sensor, Side Impact Sensor, Seat Belt
with Pre-tensioner, Seat slide sensor, Front seat
assenbly. If any of these components are diag-
nosed as faulty, they should only be replaced, in
accordance with the INDIVIDUAL COMPONENT
SERVICE procedures in this manual, starting on
•
Do not attempt to repair the wiring harness con-
nectors of the SRS. If any of the connectors are
diagnosed as faulty, replace the wiring harness. If
the wires are diagnosed as faulty, replace or repair
the wiring harness according to the following
table.
.
ACX00583
INSULATING TAPE
BATTERY
BATTERY CABLE (–)
AC
63
55
51
69
61
66
58
65
64
56 57
68
60
67
59
70
62
53
52 B
A
54
A
B
18
10
15
7
13
5
14
6
16
8
17
9
19
11
20
12
1 2
3 4
42
31
38
27
21
41
28
39
22
30
25
47
36
33
44
34
45
37
48
26
29
23
40
32
43
35
46
24
B
A
AC3001278AB
SRS-ECU CONNECTOR
SERVICE PRECAUTIONS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-27
SRS-ECU TERMINAL
NO.
DESTINATION OF HARNESS
CORRECTIVE ACTION
1, 2
Floor wiring harness
→ Seat slide
sensor
Correct or replace the floor wiring
harness.
3
Floor wiring harness
→ Driver’s seat
belt switch for N/C terminal
Correct or replace the floor wiring
harness.
4
Floor wiring harness
→ Driver’s seat
belt switch for COM terminal
Correct or replace the floor wiring
harness.
7, 8
Floor wiring harness
→ Seat belt
pre-tensioner (LH)
Correct or replace the floor wiring
harness.
9*, 10*
Floor wiring harness
→ Side-airbag
module (LH)
Correct or replace the floor wiring
harness.
18
Floor wiring harness
→ Driver’s seat
belt switch for N/O terminal
Correct or replace the floor wiring
harness.
19*, 20*
Floor wiring harness
→ Side impact
sensor (LH)
Correct or replace the floor wiring
harness.
21
Floor wiring harness
→ Instrument
panel wiring harness
→ Air bag off
indicator light
Correct or replace each wiring harness.
23
Floor wiring harness
→ Instrument
panel wiring harness
→ Junction block
(fuse No.22)
Correct or replace each wiring harness.
24
Floor wiring harness
→ Instrument
panel wiring harness
→ Junction block
(fuse No.23)
Correct or replace each wiring harness.
27, 28
Floor wiring harness
→ Instrument
panel wiring harness
→ Air bag module
(Front passenger's side) <1st squib
side>
Correct or replace each wiring harness.
30, 31
Floor wiring harness
→ Instrument
panel wiring harness
→ Air bag module
(Front passenger's side) <2nd squib
side>
Correct or replace each wiring harness.
32
Can line
Correct or replace can line.
33, 34
Floor wiring harness
→ Instrument
panel wiring harness
→ Clock spring →
Air bag module (Driver's side) <2nd
squib side>
Correct or replace each wiring harness.
Replace the clock spring.
36, 37
Floor wiring harness
→ Instrument
panel wiring harness
→ Clock spring →
Air bag module (Driver's side) <1st
squib side>
Correct or replace each wiring harness.
Replace the clock spring.
38, 39
Floor wiring harness
→ Instrument
panel wiring harness
→ Front wiring
harness
→ Front impact sensor (LH)
Correct or replace each wiring harness.
40
Floor wiring harness
→ Ground
Correct or replace the floor wiring
harness.
SERVICE PRECAUTIONS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
52B-28
NOTE: *Vehicles with side-airbags
.
42
Floor wiring harness
→ Instrument
panel wiring harness
→ Seat belt
warning light
Correct or replace each wiring harness.
43
Can line
Correct or replace can line.
47, 48
Floor wiring harness
→ Instrument
panel wiring harness
→ Front impact
sensor (RH)
Correct or replace each wiring harness.
51
Floor wiring harness
→ Passenger’s
seat belt switch for COM terminal
Correct or replace the floor wiring
harness.
52
Floor wiring harness
→ Passenger’s
seat belt switch for N/C terminal
Correct or replace the floor wiring
harness.
57*, 58*
Floor wiring harness
→ Side-airbag
module (RH)
Correct or replace the floor wiring
harness.
59, 60
Floor wiring harness
→ Seat belt
pre-tensioner (RH)
Correct or replace the floor wiring
harness.
63*, 64*
Floor wiring harness
→ Side impact
sensor (RH)
Correct or replace the floor wiring
harness.
65
Floor wiring harness
→ Passenger’s
seat belt switch for N/O terminal
Correct or replace the floor wiring
harness.
66
Floor wiring harness
→ Occupant
classification sensor
Correct or replace the floor wiring
harness.
SRS-ECU TERMINAL
NO.
DESTINATION OF HARNESS
CORRECTIVE ACTION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст