Mitsubishi Galant (2004+). Manual — part 1337
![](/vehicles/winoney/jucether/plouro/babali.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <3.8L ENGINE>
13B-1041
INSPECTION PROCEDURE 26: Generator output voltage is low (approximately 12.3 volts).
.
CIRCUIT OPERATION
• The PCM controls generator out put current by
duty-controlling continuity between the generator
G terminal (terminal No. 1) and ground.
.
TROUBLESHOOTING HINTS (The most likely
causes for this charging system:)
• Malfunction of the charging system.
• Short circuit in harness between generator G ter-
minal and PCM.
• PCM failed.
AK302876
BLA
CK-RED
POWERTRAIN CONTROL
MODULE (PCM)
GENERATOR
VOLTAGE
REGULATOR
B-116
(MU802046)
1
132
B-23
Generator Circuit
4
3
2
1
121 122 123 124 125 126 127
128 129 130 131 132 133
134 135 136 137 138 139 140
141 142 143 144 145 146
147 148 149 150 151 152 153
AK303059
CONNECTOR: B-23
PCM
AB
AIR CLEANER
B-23
AK303166AB
CONNECTOR: B-116
B-116 (GR)
![](/vehicles/winoney/jucether/plouro/yede.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <3.8L ENGINE>
13B-1042
DIAGNOSIS
Required Special Tool:
• MB991923: Power Train ECU Check Harness
STEP 1. Measure the voltage at PCM connector B-23 by
using check harness special tool MB991923.
(1) Disconnect the all PCM connectors and connect check
harness special tool MB991923 between the separated
connectors.
(2) Start the engine and run at idle.
127 126 125 124 123 122 121
133 132 131 130 129 128
140 139 138 137 136 135 134
146 145 144 143 142 141
153 152 151 150 149 148 147
AK303058
HARNESS CONNECTOR:
COMPONENT SIDE
CONNECTOR: B-23
B-23
PCM
AB
AIR CLEANER
AK202954
127 126 125 124 123 122 121
133 132 131 130 129 128
140 139 138 137 136 135 134
146 145 144 143 142 141
153 152 151 150 149 148 147
AB
POWER PLANT ECU
CHECK HARNESS CONNECTOR
MB991923
PCM
![](/vehicles/winoney/jucether/plouro/zyodng.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <3.8L ENGINE>
13B-1043
NOTE: Vehicles for Canada, the headlight, taillight, etc.
remain lit even when the lighting switch is in "OFF" position
but this is no problem for checks.
(3) Measure the voltage between terminal No. 132 and ground.
a. Engine: warming up
b. Radiator fan: stopped
c. Headlight switch: OFF to ON
d. Rear defogger switch: OFF to ON
e. Stoplight switch: OFF to ON
• Voltage rises by 0.2 − 3.5 volts.
(4) Turn the ignition switch to the "LOCK" (OFF) position.
Q: Is the harness measured voltage within the specified
range?
YES : Go to Step 2.
NO : Replace the generator. Then confirm that the
malfunction symptom is eliminated.
127 126 125 124 123 122 121
133 132 131 130 129 128
140 139 138 137 136 135 134
146 145 144 143 142 141
153 152 151 150 149 148 147
AK203183AB
POWER PLANT ECU
CHECK HARNESS
CONNECTOR
![](/vehicles/winoney/jucether/plouro/kaistrouto.png)
MULTIPORT FUEL INJECTION (MFI) DIAGNOSIS
TSB Revision
MULTIPORT FUEL INJECTION (MFI) <3.8L ENGINE>
13B-1044
STEP 2. Check harness connector B-23 at PCM connector
and harness connector B-116 at generator connector for
damage.
Q: Is the connector in good condition?
YES : Go to Step 3.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Then confirm that the
malfunction symptom is eliminated.
127 126 125 124 123 122 121
133 132 131 130 129 128
140 139 138 137 136 135 134
146 145 144 143 142 141
153 152 151 150 149 148 147
AK303058
HARNESS CONNECTOR:
COMPONENT SIDE
CONNECTOR: B-23
B-23
PCM
AB
AIR CLEANER
AK303168
2
1
3
4
AB
CONNECTOR: B-116
B-116 (GR)
HARNESS
CONNECTOR:
COMPONENT SIDE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст