Mitsubishi Galant 9G. Manual — part 105
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-416
Seat belt indicator
AC305420
ON
OFF
ON (UNFASTENED)
OFF (FASTENED)
ON (ILLUMINATED)
OFF (NOT ILLUMINATED)
IGNITION SWITCH (IG1)
SEAT BELT
SWITCH
(DRIVER'S SIDE)
SEAT BELT
WARNING
LIGHT
AC
AC305443
ON
OFF
ON (UNFASTENED)
OFF (FASTENED)
ON (ILLUMINATED)
OFF (NOT ILLUMINATED)
IGNITION SWITCH (IG1)
SEAT BELT
SWITCH
(DRIVER'S SIDE)
SEAT BELT
WARNING
LIGHT
8 km/h (5 mph)
0 km/h (0 mph)
VEHICLE SPEED
e
3 km/h (2 mph)
ON
OFF
a: 0.48 SECOND
b: 0.52 SECOND
c: 1 SECOND
d: 3 SECONDS
e: 60 SECONDS OR MORE
f: 10 SECONDS
AB
a
g
g
g
f
b
c
c
c
c
c
d
12 CYCLES
1 CYCLE
12 CYCLES
12 CYCLES
12 CYCLES
SEAT BELT
WARNING
LIGHT
g: 0.5 SECOND
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-417
If any of the following conditions is met with the igni-
tion switch at "ON" or "ST", the ETACS-ECU illumi-
nates, flashes or extinguishes the seat belt indicator
by using the driver's seat belt switch signal and the
vehicle speed signal sent from the combination
meter.
• Illuminates when the ignition switch is at "ON"
and the seat belt switch is turned on (the driver's
seat belt is unfastened).
• Flashes and illuminates the indicator 12 cycles
(after 0.5 seconds) if any of the following condi-
tions is met when sixty seconds or more have
elapsed since the ignition switch is turned "ON".
One cycle consists of five-second "flashing" and
then three-second "illumination".
a. The vehicle speed has reached 8 km/h (5
mph) while the seat belt switch is turned on
(driver's seat belt is not fastened) with the
ignition switch "ON.
b. The seat belt switch has been turned on
(driver's seat belt has not been fastened) for
at least ten seconds while the ignition switch
has been turned "ON" and the vehicle speed
has been 8 km/h (5 mph) or more.
NOTE: Once this timer operation has been acti-
vated, it will not be activated again until the
vehicle speed reduces to 3 km/h (2 mph) or
less even if any of the following conditions is
met.
• The indicator stops illuminating if the ignition
switch or the seat belt switch is turned off (the
driver's seat belt is fastened) while the timer
operation is active.
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-418
General circuit diagram for interior lights
JUNCTION BLOCK
22
RELAY BOX
(FUSE )
RELAY BOX
(FUSE )
23
ETACS-
ECU
IGNITION
SWITCH (IG1)
IGNITION
SWITCH (ACC)
KEY REMINDER
SWITCH
FRONT
DOOR
SWITCH (LH)
FRONT
DOOR
SWITCH (RH)
FRONT DOOR
LOCK ACTUATOR (LH)
REAR
DOOR
SWITCH (LH)
REAR
DOOR
SWITCH (RH)
TRUNK LID
LATCH
ASSEMBLY
KEY REMINDER
SWITCH
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-419
JUNCTION BLOCK
NOTE
WITHOUT SUNROOF
WITH SUNROOF
ETACS-
ECU
REAR DOME LIGHT
MAP LIGHT ASSEMBLY
OVERHEAD CONSOLE ASSEMBLY
TRUNK LIGHT
RELAY
BOX
(FUSE )
IGNITION
SWITCH (IG1)
COMBINATION
METER
22
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст