Mitsubishi L200. Manual — part 758
HANDS FREE-ECU
CHASSIS ELECTRICAL
54A-399
CONSTRUCTION DIAGRAM
ACB01730
ACB01729
Hands free ECU
Heater blower
assembly
Glove box
Microphone assembly
Microphone assembly
<Vehicles with sunroof>
<Vehicles without sunroof>
Steering wheel
voice control switch
USB connector
“Speech”
switch
“Pick-up”
switch
“Hang-up” switch
AC
HANDS FREE-ECU
CHASSIS ELECTRICAL
54A-400
SYSTEM BLOCK DIAGRAM
ACB00791
Speaker
Steering wheel voice
control switch
Bluetooth
R
Phone voice
or
music
Voice
Microphone power
Microphone assembly
Hands free ECU
Radio and CD player
or
Multivision display
Communication
USB
connector
Music
Audio control
USB device
Bluetooth device
R
AC
HANDS FREE-ECU
CHASSIS ELECTRICAL
54A-401
SPECIAL TOOLS
M1544403500210
TROUBLESHOOTING
INTRODUCTION TO DIAGNOSIS
M1544404500291
Prior to the troubleshooting, check if the causes below can be the case. If any, take actions according to the
solution method.
Tool
Number
Name
Use
MB991223
a. MB991219
b. MB991220
c. MB991221
d. MB991222
Harness set
a. Check harness
b. LED harness
c. LED harness
adapter
d. Probe
Continuity check and voltage
measurement at harness wire or
connector
a. For checking connector pin
contact pressure
b. For checking power supply
circuit
c. For checking power supply
circuit
d. For connecting a locally
sourced tester
MB992006
Extra fine probe
Continuity check and voltage
measurement at harness wire or
connector
MB991223
a
d
c
b
DO NOT USE
BA
MB992006
HANDS FREE-ECU
CHASSIS ELECTRICAL
54A-402
Pairing of the bluetooth
®device (mobile phone or music player) and hands free ECU cannot be made.
The hands free ECU does not recognize the bluetooth
®device (mobile phone or music player).
Calling cannot be made using the hands free cellular phone function.
Bluetooth
®The music player cannot be replayed.
The music data received from the USB adapter cannot be replayed.
Cause
SOLUTION
The power of the
bluetooth
®device is off.
With the power of the bluetooth
®device turned on, check the trouble
symptom again.
In addition to the
bluetooth
®device to be
recognized, two or more
bluetooth
®device exist in the
vehicle.
• With the voice operation, select the device to be connected.
• Select the device to be connected on the multivision display.
Power supply abnormality in
the hands free ECU, or
communication error
between the the radio and
CD player or multivition
display, and hands free
ECU.
Turn the electric motor switch to the "ON" position and check if iPod
connected to the USB adapter or USB device can be played. If the music
cannot be played, the power supply of hands free ECU or the communication
between the the radio and CD player or multivition display, and hands free
ECU may have a problem. Perform the Inspection procedure 2: The USB
memory device data cannot be replayed (Refer to
radio and CD player> or
<vehicles with MMCS>). If the diagnosis
mode of hands free ECU can be made an entry, the module status can be
checked by the hands free ECU self-check, however, if the power supply of
hands free ECU, or the communication with the the radio and CD player or
multivition display may have a problem, the module status can not be
checked (Refer to
<vehicles with radio and CD player> or
<vehicles with MMCS>).
Cause
SOLUTION
The Bluetooth
® connection
is not made between the
hands free ECU and
bluetooth
®device.
Connect the bluetooth
®device to the hands free ECU via Bluetooth®.
The vehicle is not located in
the communication area of
the cellular phone.
Check the radio wave condition of the cellular phone shown on the display, or
check the radio wave condition shown on the cellular phone itself.
AUDIO communication error
between the hands free ECU
and the the radio and CD
player or multivition display.
Check if the data of music file sent to the hands free ECU can be replayed. If
there are no problems, the communication between the hands free ECU and
the the radio and CD player or multivition display may have a problem.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст