Mitsubishi Lancer Evolution 7. Manual — part 88
CIRCUIT DIAGRAMS
H1J03X07AA
B-83
IGNITION SYSTEM
R.H. drive vehicles
CIRCUIT DIAGRAMS
H1J04X04AA
B-84
CHARGING SYSTEM
CIRCUIT DIAGRAMS
B-85
CHARGING SYSTEM (See P.B-84.)
OPERATION
When engine is stationary
D
When the ignition switch is turned to the ON
position, current flows the alternator L terminal
and, at the same time, the charge warning lamp
illuminates.
When engine is started and after engine has
started
D
When the engine is started, the charge warning
lamp goes out because of the charging voltage
begin applied to the alternator L terminal.
D
The battery voltage being applied to the
alternator S terminal is monitored by the voltage
regulator. Therefore, the amount of electricity
produced by the alternator is controlled by
allowing and cutting off the current flowing to
the field coil.
D
The alternator B terminal supplies power to
each load.
TROUBLESHOOTING HINTS
1. Charging indicator lamp does not illuminate
when the ignition switch is turned to ON
position, before the engine starts.
D
Check multi-purpose fuse No.(2).
D
Check the bulb.
2. Charging indicator lamp fails to switch off once
the engine starts.
D
Check voltage regulator of alternator.
3. Discharged or overcharged battery.
D
Check voltage regulator of alternator.
4. Charge warning lamp illuminates dimly.
D
Check combination meter diode (for short).
CIRCUIT DIAGRAMS
B-86
ENGINE CONTROL SYSTEM
L.H. drive vehicles
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст