Mitsubishi Lancer Evolution 7. Manual — part 336
BODY -
Fender
42-5
FENDER
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operations
D
Front Bumper Removal and Installation (Refer to
GROUP 51.)
D
Front Deck Garnish Removal and Installation (Refer
to GROUP 51.)
1
3
2
4
5
Removal steps
D
Side air dam (Refer to GROUP
51.)
1. Splash shield
A
A" "BA 2. Side turn signal lamp (Refer to
GROUP 54A.)
3. Deck garnish (Refer to GROUP
51-Windshield Wiper and Washer)
"
AA 4. Fender
5. Front fender bracket
BODY -
Fender
42-6
REMOVAL SERVICE POINTS
A
A" SIDE TURN SIGNAL LAMP REMOVAL
Use the special tool to release the claw part of the fender
panel and remove the side turn signal lamp.
INSTALLATION SERVICE POINT
"
AA FENDER INSTALLATION
Caution
Use the special parts as the aluminum fender uses special
coatings on the fender mounting bolt and the washer.
"
BA SIDE TURN SIGNAL LAMP INSTALLATION
Engage the hook into the fender panel, and then install the
side turn signal lamp.
Claw part
A
Section A-A
A
Front of vehicle
Side turn signal lamp
Fender panel
MB990784
MB990784
Claw
Hook
Fender
panel
Fender
panel
Front of vehicle
BODY -
Fuel Filler Door
42-7
FUEL FILLER DOOR
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operations
D
Rear Seat Removal and Installation. (Refer to GROUP
52A.)
D
Front Scuff Plate (Driver’s Side), Rear Scuff Plate
(Driver’s Side), Center Pillar Lower Trim (Driver’s
Side), Quarter Trim (Driver’s Side) Removal and
Installation (Refer to GROUP 52A – Trim.)
5
1
3
4
3
2
5.0 ± 1.0 N·m
Adjustment of clearance around
fuel filler door
Removal steps
1. Fuel filler door panel assembly
2. Clip
3. Fuel filler door hook assembly
4. Fuel filler door lock release cable
5. Fuel filler door lock release handle
BODY -
Strut Tower Bar and Rear End Cross Bar
42-8
STRUT TOWER BAR AND REAR END CROSS BAR
REMOVAL AND INSTALLATION
44 ± 5 N·m
Strut tower bar
Rear end cross bar
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст