Mitsubishi Lancer Evolution 7. Manual — part 272
25-1
PROPELLER
SHAFT
CONTENTS
. . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PROPELLER SHAFT -
General Information/Service Specification/
Lubricant/Sealant/Special Tool
25-2
GENERAL INFORMATION
3 way split 4-joint type propeller shaft with center bearing is adopted.
SERVICE SPECIFICATION
Items
Standard value
Limit
Propeller shaft runout mm
-
0.5
LUBRICANT
Items
Specified lubricant
Quantity
Front propeller shaft sleeve
yoke
Hypoid gear oil SAE 75W-90 or 75W-85W or 80W
conforming to API GL-4
As required
LJ assembly
Repair kit grease
75 ± 5 g
SEALANT
Items
Specified sealants
Remarks
LJ assembly rubber packing
3M Stud Locking 4170 or equivalent
Anaerobic sealant
SPECIAL TOOL
Tool
Number
Name
Use
MB998801
Bearing remover
Removal of the center bearing assembly
PROPELLER SHAFT - Propeller Shaft
25-3
PROPELLER SHAFT
REMOVAL AND INSTALLATION
Gear Oil: Hypoid gear oil SAE 75W-90 or
75W-85W or 80W conforming to API GL-4
1
3
2
2
1
1
1
30 ± 4 N·m
32 ± 2 N·m
30 ± 4 N·m
Removal steps
1. Insulator
2. Spacer
A
A" "AA 3. Propeller shaft assembly
REMOVAL SERVICE POINT
A
A" PROPELLER SHAFT ASSEMBLY REMOVAL
1. Make mating marks on the differential companion flange
and flange yoke, and then remove the front propeller
shaft assembly.
2. By filling rag in the boot and align the propeller shaft,
remove the propeller shaft assembly
Caution
If the joint part is bent, the joint boot is danger of
damage by folding joint boot.
A10C0017
Joint assembly
Center propeller
shaft
Joint boot
Rag
PROPELLER SHAFT - Propeller Shaft
25-4
INSTALLATION SERVICE POINT
"
AA PROPELLER SHAFT ASSEMBLY INSTALLATION
When reusing the propeller shaft, align the mating marks
made during the removal and install the propeller shaft
assembly to the companion flange.
Caution
1. Do not damage the oil seal lips of the transmission
and transfer.
2. Wipe out oil and grease on the threads of the mounting
bolts and nuts before tightening, or they will loosen.
3. If the joint part is bent, the joint boot is in danger
of damage by folding joint boot.
INSPECTION
PROPELLER SHAFT RUNOUT
Limit: 0.5 mm
Oil seal
Transfer
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст