Mitsubishi Lancer Evolution 7. Manual — part 34
INTERIOR –
Seat
INTERIOR –
Seat
6-5
SEAT
FRONT SEAT
D
The most suitable driving position can be set
by the sliding and reclining mechanism. <RS>
D
Height adjustment function to secure the most
suitable driving posture has been adopted at
the driver’s seat. <RS>
D
RECARO seat adopting non-step adjustment
slide and reclining mechanism have been
equipped. <RS-II>
Head restraint
vertical adjustment
Reclining adjustment
Sliding adjustment
Height adjustment
Reclining adjustment
Sliding adjustment
RECARO seat
REAR SEAT
D
The rear seats have been set with the low back
bench seat.
<Low back bench seat>
INTERIOR –
Seat Belt
6-6
SEAT BELT
FRONT SEAT BELT
D
The adoption of 3-point seat belt with ELR which
has belt adjustment device for height and the
buckle fixed at the seat have secured the most
suitable fitting for the wearer.
D
The seat belt retractor with the pre-tensioner
and the force limiter for the driver’s seat and
the front passenger’s seat has been adopted
to improve safety.
REAR SEAT BELT
D
3-point seat belts with ALR/ELR (L.H./R.H./cen-
ter) have been installed.
CONSTRUCTION DIAGRAM
Buckle (L.H./R.H.)
Belt adjustment device (L.H./R.H.)
3-point seat belt
with ELR
(L.H./R.H.)
3-point seat belt with
ALR/ELR (L.H./R.H./center)
Seat belt retractor with the pre-tensioner and
the force limiter (L.H./R.H.)
Seat belt retractor (L.H./R.H./center)
INTERIOR –
Seat Belt
6-7
SEAT BELT RETRACTOR WITH FORCE LIMITER
The driver’s/front passenger’s seat belt retractor
has been equipped with a force limiter. The force lim-
iter is a device which operates when a predeter-
mined force is applied, and limits the force.
Seat belt retractor with
force limiter
OPERATION
(1) If a collision energy is transmitted to the seat belt, the
ELR mechanism will operate to lock the seat belt.
(2) Then, if the energy increases to a predetermined value,
the torsion bar will be distorted. As the spool rotates
together with the torsion bar, the seat belt webbing is
pulled out, reducing impact on the occupants.
Belt
Spool
Torsion bar
INTERIOR –
Interior Trims
6-8
INTERIOR TRIMS
D
The interiors are fully covered by trims to
enhance product value.
D
The adoption of the energy absorption rib mold
located in the rear of the front pillar trim and
the rear pillar trim to protect head from the
side impact and the resin materials for the trims
as unbreakable materials has increased safety
as outstanding interiors.
D
Use of inflammable materials for the trims has
increased safety as outstanding interiors. Also,
material codes are indicated to deal with
recycling easily.
CONSTRUCTION DIAGRAM
Front scuff plate
Cowl side trim
Front pillar trim
Center pillar lower trim
Center pillar upper trim
Rear pillar trim
Rear scuff plate
Partition board
Front pillar trim
(back side)
Energy absorption rib
Rear shelf trim
Retractor trim
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст