Mitsubishi Evolution X. Manual — part 589
DIAGNOSIS
TSB Revision
KEYLESS OPERATION SYSTEM (KOS)
42B-263
12
Receiver antenna module CLOCK
output
• When communicating with the
keyless operation key with the
emergency key inserted in the
inverted direction (ignition
switch: ON)
• Keyless operation key lock
button, unlock button, and trunk
lid button: ON
0 to 5 V (pulse signal)
Receiver antenna assembly
CLOCK output
13
Receiver antenna module power
control
Ignition switch: OFF
0 to 5 V (pulse signal)
Receiver antenna assembly power
control
14
Ground
Always
0 V
15
−
−
−
16
Interior transmitter antenna
assembly (front) signal output
When IG push switch is pressed
0 to 5 V (pulse signal)
or 0 to 8 V (pulse
signal)
17
Exterior transmitter antenna
assembly (driver's side) signal
output
When the front door outside
handle (driver's side) is gripped, or
when the lock switch (driver's
side) is pressed
0 to 8 V (pulse signal)
18
Exterior transmitter antenna
assembly (front passenger's side)
signal output
When the front door outside
handle (front passenger's) is
gripped, or when the lock switch
(front passenger's) is pressed
0 to 8 V (pulse signal)
19
Exterior transmitter antenna
assembly (trunk lid) signal output
When trunk lid opener switch is
pressed
0 to 8 V (pulse signal)
20
Interior transmitter antenna
assembly (rear) signal output
When IG push switch is pressed
0 to 5 V (pulse signal)
or 0 to 8 V (pulse
signal)
21
Lock switch (driver's side) output
Lock switch: ON
0 V
22
−
−
−
23
Lock switch (front passenger's side)
output
Lock switch: ON
0 V
24
Unlock sensor (driver's side) signal
output
When the front door outside
handle (driver's side) is grasped
0 V
25
Unlock sensor (front passenger's
side) signal output
When the front door outside
handle (front passenger's side) is
grasped
0 V
26, 27
−
−
−
28
Trunk lid opener switch output
Trunk lid opener switch: ON
0 V
29, 30
−
−
−
31
Steering lock unit ground
Always
0 V
32
Receiver antenna module ground
Always
0 V
Receiver antenna assembly ground
Terminal
number
Check item
Check condition
Normal condition
DIAGNOSIS
TSB Revision
KEYLESS OPERATION SYSTEM (KOS)
42B-264
33
−
−
−
34
Push switch inside the steering lock
power supply
Push switch inside the steering
lock: OFF
12V
35
Output to outer tone alarm (-)
Outer tone alarm is sounding
0 to 12 V (pulse signal)
36
Unlock sensor (driver's) power
supply
Always
0 to 10 V (pulse signal)
Unlock sensor (front passenger's
side) power supply
37
Output to outer tone alarm (+)
Outer tone alarm is sounding
0 to 12 V (pulse signal)
38
Battery power supply
Always
Battery voltage
39
Power supply from ignition switch
(IG1)
Ignition switch: ON
Battery voltage
40
Interior transmitter antenna
assembly (front) power supply
• At the door switch operation
• At the ignition switch operation
• At door open/close
5 V
Interior transmitter antenna
assembly (rear) power supply
Exterior transmitter antenna
assembly (driver's side) power
supply
8 V
Exterior transmitter antenna
assembly (front passenger's side)
power supply
Exterior transmitter antenna
assembly (trunk lid) power supply
Terminal
number
Check item
Check condition
Normal condition
ON-VEHICLE SERVICE
TSB Revision
KEYLESS OPERATION SYSTEM (KOS)
42B-265
ON-VEHICLE SERVICE
ID CODES REGISTRATION PROCEDURES
M1429611700242
REGISTRATION USING SCAN TOOL MB991958
(M.U.T.-III SUB ASSEMBLY)
Required Special Tools:
• MB991958 Scan Tool (M.U.T.-III Sub Assembly)
• MB991824: Vehicle Communication Interface (V.C.I.)
• MB991827 M.U.T.-III USB Cable
• MB991910 M.U.T.-III Main Harness A
By operating the scan tool MB991958 (M.U.T.-III sub assembly)
screen, the ID code registration and the TPMS can be regis-
tered and antenna communication required to the keyless oper-
ation system can be performed. KOS and keyless operation
key are indicated as F.A.S.T and F.A.S.T.-key respectively in
the scan tool MB991958 (M.U.T.-III sub assembly) screen.
CAUTION
Do not register the keyless operation key registered for
other vehicles.
SUPPLY UNIT LIST FOR INDIVIDUAL KEY
KEY SUPPLY UNIT LIST FOR OTHER THAN INDIVIDUAL KEY
KOS emergency key
KOS key
AC610642
AC709685
Full service key set
Handle lock service key set
AC610158
AC610159
ON-VEHICLE SERVICE
TSB Revision
KEYLESS OPERATION SYSTEM (KOS)
42B-266
NOTE:
.
•
When re-registering the key (key ID and keyless operation
key ID), all the keys (key ID and keyless operation key ID)
registered before must be re-registered because all of them
will be erased.
•
For registration, the keyless operation key and the emer-
gency key are needed.
•
If the registration fails, repeat from the start.
•
After the keyless operation key is registered, start the
engine with all the keys and keyless operation keys, and
check that KOS operates normally.
Door service key set
NOTE: Key (It is the key that comes with the door
service key set. It can only be used for locking
and unlocking, and it cannot start the engine.)
AC610062
AC607881
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст