Mitsubishi Evolution X. Manual — part 956
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-185
REMOVAL SERVICE POINT
.
<<A>> HEADLIGHT (LOW-BEAM) BULB
REMOVAL <VEHICLES WITH DISCHARGE
HEADLIGHT>
CAUTION
Do not touch the bulb surface with bare hands or dirty
gloves. If the bulb surface (glass part) gets dirty, immedi-
ately clean it with alcohol or thinner. After drying com-
pletely, install the bulb.
1. Twist the socket cover to remove.
2. Disconnect the igniter.
3. Release the bulb securing spring, and remove the bulb.
AC609615
AC
Socket cover
AC609658
AB
Igniter
AC609659
AB
Spring
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-186
HEADLIGHT LEVELING SWITCH REMOVAL AND INSTALLATION
M1540105200137
AC709250
AB
1
2
Removal Steps
1.
Instrument panel cover assembly
(Refer to GROUP 52A
− Instrument
Lower Panel
2.
Headlight leveling switch
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-187
LIGHTING CONTROL SENSOR REMOVAL AND INSTALLATION
M1540108500126
AC709252
Optical coupler
AB
1
2
3
Note
: Claw positions
A
A
Section A - A
Section B - B
Section C - C
Section D - D
Optical coupler
3
D
C
B
D
C
1
1
1
Claw
Claw
Lighting control
sensor bracket
Lighting control
sensor bracket
Lighting control
sensor bracket
Lighting control
sensor bracket
Claw
Claw
Claw
B
Removal Steps
1.
Lighting control sensor cover
2.
Connector
<<
A
>>
>>
A
3.
Lighting control sensor
Removal Steps (Continued)
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-188
REMOVAL SERVICE POINT
.
<<A>> LIGHTING CONTROL SENSOR REMOVAL
While pushing the clamp to the windshield side, pry up the
clamp to disengage the right and left claws using the screw-
driver (
−), and then remove the lighting control sensor.
INSTALLATION SERVICE POINT
.
>>A<< LIGHTING CONTROL SENSOR INSTALLA-
TION
CAUTION
After executing the lighting control sensor (rain sensor)
adaptation, do not touch the lighting control sensor (or do
not move it from the fixed position).
• Mount the lighting control sensor onto the optical coupler,
and then connect the connector.
• When reusing the lighting control sensor or when the light-
ing control sensor is pushed to check the installation condi-
tion, install the connector and the lighting control sensor
cover and wipe the windshield thoroughly. When the wind-
shield is dry, execute the lighting control sensor (rain sen-
sor) adaptation. <Refer to GROUP 51
− Lighting Control
Sensor (Rain Sensor) Adaptation
NOTE: Be careful not to touch the lighting control sensor
receiver. (The lighting control sensor receiver has limited resis-
tance to oil.)
AC700066
Screwdriver (-)
AG
Claw
Lighting
control
sensor
Clamp
Push
Push
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст