Mitsubishi Evolution X. Manual — part 881
CALIFORNIA PROPOSITION 65 WARNING
• This product contains or emits chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm.
WARNINGS REGARDING SERVICING OF SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) EQUIPPED VEHICLES
• Improper service or maintenance of any component of the SRS, or any SRS-related component,
can lead to personal injury or death to service personnel (from inadvertent firing of the air bag)
or to the driver and passenger (from rendering the SRS inoperative).
• If it is possible that the SRS components are subjected to heat over 93 °C (200 °F) in baking or in
drying after painting, remove the SRS components [air bag module (driver's side and front
passenger's side), SRS-ECU, clock spring, side impact sensor, front seat assembly (side air bag
module)] beforehand.
• Service or maintenance of any SRS component or SRS-related component must be performed
only at an authorized MITSUBISHI dealer.
• MITSUBISHI dealer personnel must thoroughly review this manual, and especially its GROUP
52B, Supplemental Restraint System (SRS), before beginning any service or maintenance of any
component of the SRS or any SRS-related component.
NOTE
Section titles with the asterisks (*) in the table of contents in each group indicate operations requiring
warnings.
WARNING
WARNING
MITSUBISHI PUBLICATION COMMENT FORM
Use this form to advise us of any errors you might find in this publication. We also welcome your
suggestions that might help us improve Mitsubishi publications.
Publication that contains error: __________________________________________________________
Page number where the error appears:____________________________________________________
Figure number where the error appears:___________________________________________________
Vehicle application and system identification: _______________________________________________
Describe, in detail, the error found or your suggestion. Please attach additional pages as necessary.
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
___________________________________________________________________________________
Dealer ___________________________________ Dealer Code________________________________
From: Name_________________________________________________________________________
City/Town____________________________ State________________ Zip Code______________
Signature ____________________________ Date ________________ Phone________________
Mail To: Mitsubishi Motors North America, Inc.
6400 Katella Avenue
P.O. Box 6400
Cypress, California 90630-0064
Attn: Technical Information Dept.
Fax to: Mitsubishi Motors North America, Inc.
Technical Information Dept.
(714) 373-1021
25-1
GROUP 25
PROPELLER SHAFT
CONTENTS
GENERAL INFORMATION . . . . . . . .
GENERAL SPECIFICATIONS . . . . . .
SERVICE SPECIFICATION . . . . . . . .
LUBRICANTS . . . . . . . . . . . . . . . . . .
SEALANT. . . . . . . . . . . . . . . . . . . . . .
PROPELLER SHAFT DIAGNOSIS . .
INTRODUCTION TO PROPELLER SHAFT
DIAGNOSIS . . . . . . . . . . . . . . . . . . . . . . . .
PROPELLER SHAFT DIAGNOSTIC
TROUBLESHOOTING STRATEGY . . . . . .
SYMPTOM CHART . . . . . . . . . . . . . . . . . . .
SYMPTOM PROCEDURES . . . . . . . . . . . .
SPECIAL TOOL . . . . . . . . . . . . . . . . .
PROPELLER SHAFT . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . . . . . .
INSPECTION. . . . . . . . . . . . . . . . . . . . . . . .
DISASSEMBLY AND ASSEMBLY . . . . . . .
GENERAL INFORMATION
TSB Revision
PROPELLER SHAFT
25-2
GENERAL INFORMATION
M1251000100465
The 3-piece, 4-joint type propeller shaft with a center
bearing is adopted.
There are the following features.
• For the joint Nos. 1, 2, and 4, the caulking type
universal joint with excellent properties of bal-
ance accuracy is equipped.
• For joint No. 3, the lightweight and compact LJ
(Lebro Joint) is equipped.
• The dual anti-vibration construction is located at
the center bearing to vehicle body joint, reducing
vibration (gear noise).
• The heat protector is adopted to the center bear-
ing bracket.
• The lead-free grease is adopted for the universal
joint and LJ (Lebro Joint).
CONSTRUCTION DIAGRAM
AC704615AB
AC504845AB
Insulator
Propeller shaft
assembly (Front)
Propeller shaft
assembly (Center)
Propeller shaft
assembly (Rear)
Heat
protector
Heat protector
Sleeve yoke
No.1 joint
No.2 joint
No.3 joint (LJ)
Center bearing
No.4 joint
Center bearing
GENERAL SPECIFICATIONS
M1251000200194
Item
Specification
Propeller shaft
Type
3-piece, 4-joint type propeller shaft
Length* x Outer
diameter mm (in)
Front
517
× 65 (20.4 × 2.6)
Center
708
× 65 (27.9 × 2.6)
Rear
704
× 65 (27.7 × 2.6)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст