Mitsubishi Evolution X. Manual — part 929
COMBINATION METER
TSB Revision
CHASSIS ELECTRICAL
54A-77
STEP 4. Measure at meter information switch connector
C-02 in order to the ground circuit to the meter information
switch.
(1) Disconnect meter information switch connector C-02, and
measure at the wiring harness side.
(2) Measure the resistance value between terminal 4 and
ground.
• The measured value should be 2 ohm or less.
Q: Does the measured resistance value correspond with
this range?
YES : Go to Step 6.
NO : Go to Step 5.
STEP 5. Check the wiring harness between meter
information switch connector C-02 (terminal 4) and
ground.
Check the ground wires for open circuit.
Q: Is the wiring harness between fuel meter information
switch connector C-02 (terminal 4) and ground in good
condition?
YES : Go to Step 6.
NO : Repair the wiring harness.
STEP 6. Check combination meter connector C-04 for
loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is combination meter connector C-04 in good
condition?
YES : Go to Step 7.
NO : Repair the connector.
STEP 7. Check the wiring harness between meter
information switch connector C-02 (terminal 1) and
combination meter connector C-04 (terminal 3).
Check the output lines for open circuit.
Q: Are the wiring harness between meter information
switch connector C-02 (terminal 1) and combination
meter connector C-04 (terminal 3) in good condition?
YES : Go to Step 8.
NO : Repair the wiring harness.
AC709322 AC
Harness side: C-02
COMBINATION METER
TSB Revision
CHASSIS ELECTRICAL
54A-78
STEP 8. Retest the system.
Check that the multi information display screen switches nor-
mally when the multi information meter switch is operated.
Q: Is the check result normal?
YES : The trouble can be an intermittent malfunction (Refer
to GROUP 00
− How to use
Troubleshooting/inspection Service Points
− How to
Cope with Intermittent Malfunction
NO : Replace the combination meter.
SERVICE DATA
M1540201000257
NOTE: For some information result read out by the
ECU, the specific items may not be displayed.
Item No. Display on scan tool
Check condition
Normal
condition
01
Illumination
Taillight: Illuminated
ON
Taillight: Extinguished
OFF
02
Outside temperature
−
° F
03
Frost warning indicator
With warning display
ON
Without warning display
OFF
04
Engine coolant temp. light(HOT)
With warning display
ON
Without warning display
OFF
05
Immobilizer indicator
Always
OFF
07
AWD failure indicator
With warning display
ON
Without warning display
OFF
08
Hood indicator
With warning display
ON
Without warning display
OFF
23
A/T failure indicator(Symbol)
With warning display
ON
Without warning display
OFF
25
ASC/TCL failure indicator
With warning display
ON
Without warning display
OFF
26
Key reminder indicator
With warning display
ON
Without warning display
OFF
27
Headlight reminder indicator
With warning display
ON
Without warning display
OFF
28
Brake reminder indicator
With warning display
ON
Without warning display
OFF
29
F.A.S.T.indicator1(Low battery)
With warning display
ON
Without warning display
OFF
30
F.A.S.T.indicator2(No key)
With warning display
ON
Without warning display
OFF
31
F.A.S.T.indicator3(IG knob)
With warning display
ON
Without warning display
OFF
COMBINATION METER
TSB Revision
CHASSIS ELECTRICAL
54A-79
32
F.A.S.T.indicator4(Take out key)
With warning display
ON
Without warning display
OFF
33
F.A.S.T.indicator5(Take out key)
With warning display
ON
Without warning display
OFF
34
F.A.S.T.indicator6(Lock disable)
With warning display
ON
Without warning display
OFF
35
F.A.S.T.indicator7(Lock disable)
With warning display
ON
Without warning display
OFF
36
F.A.S.T.indicator8(Lock disable)
With warning display
ON
Without warning display
OFF
37
F.A.S.T.indicator9(System error)
With warning display
ON
Without warning display
OFF
69
Security alarm buzzer
Exterior protection is operating
ON
Exterior protection is not operating
OFF
70
Presecurity alarm buzzer
Interior alarm is operating
ON
Interior alarm is not operating
OFF
80
Speed meter
Speedometer displayed value and scan tool displayed
value agree with each other.
87
Tachometer
Tachometer displayed value and scan tool displayed
value agree with each other.
89
Fuel gauge
The resistance value of the fuel gauge unit and scan
tool displayed value agree with each other. (The
allowance shall be defined as
±2 Ω.)
8A
Fuel gauge(Target)
The remaining fuel level is displayed by %.
8C
Engine coolant temperature gauge
Coolant temperature and scan tool displayed value
agree with each other.
90
Odometer
Odometer displayed value and scan tool displayed
value agree with each other.
91
Rheostat
Lighting change by rheostat switch operation and
change of scan tool displayed value agree with each
other.
92
Trip meter A
Trip meter displayed value and scan tool displayed
value agree with each other.
93
Trip meter B
94
Power source voltage
Always
5
− 20 V
A1
SRS warning light
With warning display
ON
Without warning display
OFF
A2
ABS warning light
With warning display
ON
Without warning display
OFF
A3
Oil pressure indicator
With warning display
ON
Without warning display
OFF
Item No. Display on scan tool
Check condition
Normal
condition
COMBINATION METER
TSB Revision
CHASSIS ELECTRICAL
54A-80
A4
Charge indicator
With warning display
ON
Without warning display
OFF
A5
Engine malfunction indicator
With warning display
ON
Without warning display
OFF
A6
Fuel Warning (step1)
With warning display
ON
Without warning display
OFF
A7
Brake warning light
With warning display
ON
Without warning display
OFF
A8
Driver seatbelt indicator
With warning display
ON
Without warning display
OFF
AA
ASC/TCL Operation indicator
When the indicator illuminates
ON
When the indicator is extinguished
OFF
AB
ASC/TCL OFF indicator
When the indicator illuminates
ON
When the indicator is extinguished
OFF
B1
Turn signal indicator(Right)
Turn-signal light (RH): Illuminated
ON
Turn-signal light (RH): Extinguished
OFF
B2
Turn signal indicator(Left)
Turn-signal light (LH): Illuminated
ON
Turn-signal light (LH): Extinguished
OFF
B3
Front fog light indicator
Taillight: illuminates and fog light switch:
ON
ON
When fog lights are off
OFF
B4
High beam indicator
Dimmer switch: ON
ON
Dimmer switch: OFF
OFF
B5
Door indicator(Front Left)
Front passenger's door: Open
ON
Front passenger's door: Closed
OFF
B6
Door indicator(Front Right)
Driver's door: Open
ON
Driver's door: Closed
OFF
B7
Door indicator(Rear Left)
Rear left door: Open
ON
Rear left door: Closed
OFF
B8
Door indicator(Rear Right)
Rear right door: Open
ON
Rear right door: Closed
OFF
B9
Door indicator (Liftgate)
Trunk lid: Open
ON
Trunk lid: Closed
OFF
BA
Position light indicator
Taillight switch: ON
ON
Taillight switch: OFF
OFF
BE
A/T position indicator:Blank
The indicator is not displayed.
ON
The indicator is displayed.
OFF
BF
A/T position indicator:A
Always
OFF
C1
A/T position indicator:P
Shift lever: P position
ON
Shift lever: Other than P position
OFF
Item No. Display on scan tool
Check condition
Normal
condition
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст