Mitsubishi Evolution X. Manual — part 938
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-113
DTC B16A3: Turn-signal light (LH) short circuit
.
Turn-Signal Lights (LH) Circuit
ETACS-
ECU
REAR
COMBINATION
LIGHT
(TURN: LH)
SIDE TURN-
SIGNAL LIGHT
(LH)
HEADLIGHT
ASSEMBLY
(TURN: LH)
AC708949AG
Connectors: A-12, A-40
A-12 (B)
A-40 (B)
AC708972
Connectors: C-304, C-311
AW
C-311
C-304
AC708955AL
Connector: D-17
D-17 (BR)
AC708970AH
Connector: F-25
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-114
TROUBLE JUDGMENT
When the left wiring harness of turn-signal light is
short circuited, the ETACS-ECU sets DTC B16A3.
.
TECHNICAL DESCRIPTION (COMMENT)
When the short circuit is detected three times con-
secutively, the ETACS-ECU sets the DTC B16A3.
.
TROUBLESHOOTING HINTS
• The wiring harness or connectors may have
loose, corroded, or damaged terminals, or termi-
nals pushed back in the connector
• Malfunction of the ETACS-ECU
DIAGNOSIS
Required Special Tools:
• MB992006: Extra fine probe
• MB991223: Harness set
• MB991958: Scan Tool (M.U.T.-III Sub Assembly)
• MB991824: Vehicle Communication Interface (V.C.I.)
• MB991827: M.U.T.-III USB Cable
• MB991910: M.U.T.-III Main Harness A (Vehicles with
CAN communication system)
STEP 1. Check headlight assembly (LH) connector A-40
<front>, side turn-signal light (LH) connector A-12 <side>,
rear combination light (LH) connector F-25 <rear> for
loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Are headlight assembly (LH) connector A-40 <front>,
side turn-signal light (LH) connector A-12 <side>, rear
combination light (LH) connector F-25 <rear> in good
condition?
YES : Go to Step 2.
NO : Repair or replace the damaged component(s). Refer
to GROUP 00E, Harness Connector Inspection
STEP 2. Check ETACS-ECU connectors C-304 and C-311
for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Are ETACS-ECU connectors C-304 <front or side> and
C-311 <rear> in good condition?
YES : Go to Step 3.
NO : Replace the bulb(s) of the light that does not
illuminate.
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-115
STEP 3. Check the wiring harness between headlight
assembly (LH) connector A-40 (terminal 3) <front>, side
turn-signal light (LH) connector A-12 (terminal 2) <side>,
rear combination light (LH) connector F-25 (terminal 2)
<rear> and ETACS-ECU connector C-304 (terminal 9)
<front or side> or C-311 (terminal 18) <rear>.
NOTE: Also check intermediate connector D-17 for loose, cor-
roded, or damaged terminals, or terminals pushed back in the
connector. If intermediate connector D-17 is damaged, repair or
replace the connector as described in GROUP 00E, Harness
Connector Inspection
.
• Check the communication line for open circuit.
Q: Are the wiring harness between headlight assembly
(LH) connector A-40 (terminal 3) <front>, side
turn-signal light (LH) connector A-12 (terminal 2)
<side>, rear combination light (LH) connector F-25
(terminal 2) <rear> and ETACS-ECU connector C-304
(terminal 9) <front or side> or C-311 (terminal 18) <rear>
in good condition?
YES : Go to Step 4.
NO : The wiring harness may be damaged or the
connector(s) may have loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Repair the wiring harness as necessary. Verify that
the headlights illuminate normally.
STEP 4. Using scan tool MB991958, Check whether the
diagnostic trouble code is reset.
CAUTION
To prevent damage to scan tool MB991958, always turn the
ignition switch to the "LOCK" (OFF) position before con-
necting or disconnecting scan tool MB991958.
HEADLIGHT
TSB Revision
CHASSIS ELECTRICAL
54A-116
. (1) Connect scan tool MB991958. Refer to "How to connect
."
(2) Turn the ignition switch to the "ON" position.
(3) Erase the DTC.
(4) Turn the ignition switch from "LOCK" (OFF) position to "ON"
position.
(5) Check if DTC is set.
Q: Is the DTC set?
YES : Replace the ETACS-ECU.
NO : The procedure is complete.
DTC B16A4: Blown turn-signal light (RH) bulb
AC608435
Data link connector
MB991827
MB991824
MB991910
AB
Turn-Signal Lights (RH) Circuit
ETACS-
ECU
REAR
COMBINATION
LIGHT
(TURN: RH)
HEADLIGHT
ASSEMBLY
(TURN: RH)
SIDE TURN-
SIGNAL LIGHT
(RH)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст